757307

ESQ Aston Chronograph Manual

1
Zoom out
Zoom in
Previous page
1/2
Next page
Operating Instructions
ASTON 1/5 CHRONOGRAPH
A chronograph combines two time-keeping functions. It incorporates
a device to measure intervals of time independent of the regular time
shown on the dial. Your ESQ by Movado Aston Chronograph may be
used to time events up to two hours in duration, in 1/5 of-a-second
increments.
NOTE: After 2 hours of continuous running, the chronograph will stop
and reset automatically to preserve battery life.
Setting the Time:
1. Pull crown out to position 3. (Watch will stop.)
2. Turn crown in either direction to move hands to desired time.
Be sure to take AM/PM into account so that date changes at midnight,
not noon.
3. Push crown back in to position 1. (Watch will restart.)
NOTE: To set time to exact second, pull crown out to position 2 precisely
when small seconds hand S reaches <<60>> position. (Watch stops.)
Adjust time to one minute ahead, and take an accurate time signal, from
a radio news station, for example. When audible tone signals exact time,
immediately push crown back in to position 1. (Watch will restart, now
set to the exact time.)
Setting the Day:
1. Pull crown out to position 3. (Watch will stop.)
2. Turn crown in either direction to move hands forward or back. Each
time the hands complete a 24-hour revolution and pass midnight,
Day indicator hand F will move ahead or back by one day.
3. Once correct Day has been reached, set hands to correct Time,
following instructions above.
4. Push crown back in to position 1. (Watch will restart.)
Setting the Date:
1. Pull crown out to position 2. (Watch will keep running.)
2. Turn crown clockwise to move hands forward. Each time the hands
complete a 24-hour revolution and pass midnight, the date shown in
Date display D will advance by one number.
3. Once correct Date has been reached, push crown back in to position 1.
CAUTION: Never set the date when the hands are between 9:00 PM
and 12:30 AM, while automatic date changing is in progress. Doing so
could damage the calendar mechanism.
Chronograph Function Overview
Use buttons A and B to operate the chronograph. Pressing button A
the first time will start the chronograph. While the chronograph is run-
ning, once the chronograph fifths-of-a-second counter hand C has com-
pleted one turn, minute-counter hand E will jump ahead one minute.
Pressing button A a second time will stop the chronograph. Pressing
button B will reset chronograph hands E and C to zero. Adjusting the
time does not stop the chronograph, but it does block buttons A and B
for as long as the crown is pulled out.
IMPORTANT: Crown must be in position 1 and hands must be at zero
before chronograph is started. Press button B to reset hands to zero.
Do not push button A or B while crown is pulled to position 2 or 3.
If button A or B is accidentally activated while crown is not flush against
case, one or both chronograph hands may become de-synchronized.
Should this occur, see directions for synchronizing hands at end of
following instructions.
Simple chronograph functions:
To measure the duration of a single, non-stop event:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph, and read the 2
chronograph hands to determine elapsed time, for example: 14 minutes;
37 and 3/5 of a second.
3. Press button B to reset chronograph to zero.
Accumulated time functions:
To measure the combined time of a series of shorter events, for example
the actual playing time of a football game, where play is repeatedly
interrupted:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph again.
NOTE: Each time you stop chronograph, chronograph hands will indicate
total accumulated time.
Repeat steps 1 and 2 to add each additional interval of time.
5. After you have taken your final accumulated time reading, press button
B to reset chronograph hands to zero.
Split-time or intermediate time functions:
To take intermediate time readings as a race progresses:
1. Press button A to start chronograph.
2. Press button B to momentarily stop chronograph.
3. Read off the intermediate time, for example:10 minutes, 26 and 2/5
of a second.
Legend
H - Hour hand
M - Minute hand
S - Small seconds hand
F - Day indicator hand
C - Center-mounted chronograph fifths-of-a-second hand
E - Chronograph 30-minutes counter
D - Date display
1, 2, 3 - Crown positions
A - Chronograph start/stop push-button
B - Chronograph split/reset push-button
20
28
30
S
S
F
T
T
M
W
10 40
0
20
E
1
A
B
C
D
F
2
S
HM
3
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ESQ Aston Chronograph at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ESQ Aston Chronograph in the language / languages: English as an attachment in your email.

The manual is 0,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info