Read all of the instructions in this section when setting up and using your printer.
When choosing a place for the printer
❏Avoid places subject to rapid changes in temperature
and humidity. Also, keep the printer away from direct
sunlight, strong light, or heat sources.
❏Avoid places subject to dust, shocks, or vibrations.
❏Leave enough room around the printer to allow for
sufficient ventilation.
❏Place the printer near a wall outlet where the plug can
be easily unplugged.
❏Place the printer on a flat, stable surface that extends
beyond the base of the printer in all directions. If you
place the printer by the wall, leave more than 40 cm
between the back of the printer and the wall. The
printer will not operate properly if it is tilted at an angle.
❏When storing or transporting the printer, do not tilt it,
stand it on its side, or turn it upside down. Otherwise ink
may leak from the cartridge.
When choosing a power source
❏Use only the type of power source indicated on the
printer’s label.
❏Use only the power cord that comes with this product.
Use of another cord may result in fire or electric shock.
❏This product’s power cord is for use with this product
only. Use with other equipment may result in fire or
electric shock.
❏Be sure your AC power cord meets the relevant local
safety standard.
❏Do not use a damaged or frayed power cord.
❏If you use an extension cord with the printer, make sure
that the total ampere rating of the devices plugged
into the extension cord does not exceed the cord’s
ampere rating. Also, make sure that the total ampere
rating of all devices plugged into the wall outlet does
not exceed the wall outlet’s ampere rating.
❏If you plan to use the printer in Germany, the building
installation must be protected by a 10 or 16 amp circuit
breaker to provide adequate short-circuit protection
and over-current protection for this printer.
When handling ink cartridges
❏Keep ink cartridges out of the reach of children. Do not
allow children to drink from or otherwise handle the
cartridges.
❏Do not open the ink cartridge packages until just before
you install them.
❏Shake the new ink cartridges four or five times before
opening the packages.
❏Do not shake the ink cartridges after opening the
packages; this can cause leakage.
❏Be careful not to break the hooks on the side of the ink
cartridge when you remove it from the package.
❏Be careful when you handle used ink cartridges, as
there may be some ink remaining around the ink supply
port. If ink gets on your skin, wash the area thoroughly
with soap and water. If ink gets into your eyes, flush
them immediately with water. If discomfort or vision
problems remain after a thorough flushing, see a doctor
immediately.
❏Do not remove or tear the label on the cartridge; this
can cause leakage.
❏Do not touch the green IC chip on the side of the
cartridge.
❏The IC chip on this ink cartridge retains a variety of
cartridge related-information, such as the amount of
ink remaining, so that a cartridge may be removed and
reinserted freely. However, each time the cartridge is
inserted, some ink is consumed because the printer
automatically performs a reliability check.
❏Store ink cartridge with its label facing upward. Do not
store cartridge upside down.
When using the printer
❏Do not put your hand inside the printer or touch the ink
cartridges during printing.
❏Do not block or cover the vents and the openings in the
printer.
❏Do not attempt to service the printer yourself.
❏Unplug the printer and refer servicing to qualified
service personnel under the following conditions:
The power cord or plug is damaged; liquid has entered
the printer; the printer has been dropped or the casing
damaged; the printer does not operate normally or
exhibits a distinct change in performance.
❏Do not insert objects through the slots in the printer.
❏Take care not to spill liquid on the printer.
❏Leave the ink cartridges installed. Removing the
cartridges can dehydrate the print head and may
prevent the printer from printing.
❏When connecting this product to a computer or other
device with a cable, ensure the correct orientation of
the connectors. Each connector has only one correct
orientation. Inserting a connector in the wrong
orientation may damage both devices connected by
the cable.
Veuillez trouver les instructions en français au verso.
Need help? Post your question in this forum.
Report abuse
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Epson StylusPhotoR2400 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Epson StylusPhotoR2400 in the language / languages: English as an attachment in your email.
The manual is 1,7 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
