543654
74
Zoom out
Zoom in
Previous page
1/130
Next page
Status Cause Remedy or Status
If it is not cracked: Re-fit the lamp and turn on the power.
If the error continues: Replace the lamp with a new lamp and turn on the power.
If the error continues: Stop using the projector, disconnect the power cable from the electrical outlet, and contact your
local dealer or the nearest address provided in the Support and Service Guide. s Epson Projector Contact List
If it is cracked: Replace it with a new lamp, or contact your local dealer for further advice. (Only one lamp is working.
Replace the burned-out lamp as soon as possible.). s Epson Projector Contact List
If replacing the lamp yourself, be careful to avoid pieces of broken glass.
When using at an altitude of 1500 m or more, set High Altitude Mode to On. s p.49
Set Direction to Pointing Down or Pointing Up when the projector is installed to project downward or upward. s p.49
No Air Filter
Air Flow Sensor Err.
Check that the air filter is securely installed. s p.92
The projector automatically turns off about one minute after it detects that there is no air filter.
If the error continues even though an air filter is installed, the air filter sensor may be defective. Stop using the projector,
disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the
Support and Service Guide. s Epson Projector Contact List
Low Air Flow (This is not an abnormality. However, projection stops automatically if the airflow falls any further.)
The message "The air filter is clogged. Clean or replace the air filter." is displayed. Check the following two points.
Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
If the air filter is clogged, clean or replace it. s p.85, p.92
If the Low Air Flow continues to be low after cleaning the air filter, replace the air filter with a new one. s p.92
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide.
s Epson Projector Contact List
Air Filter Notice "Time to clean the air filter. Clean or replace the air filter." is displayed. Clean the air filter. s p.85
If the air filter is stained yellow with tobacco smoke and cannot be cleaned, replace it with a new one.
The indicators or messages regarding "Air Filter Notice" are displayed only when Air Filter Notice is set to On, on the
configuration menu's Extended menu. s p.49
q
If the projector is not operating properly, even though the indicators are all showing normal, refer to “When the Indicators Provide No Help”.
s p.75
If the error is not indicated in this table, Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or
the nearest address provided in the Support and Service Guide. s Epson Projector Contact List
Problem Solving
74
74


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson EB Z8000WU at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson EB Z8000WU in the language / languages: English as an attachment in your email.

The manual is 5,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info