656708
3
Zoom out
Zoom in
Previous page
1/16
Next page
128
For Your Safety
1. You must connect wiring according to the installation instructions. Any error in wiring
may result in the failure in or damage to the eletric system for the vehicle.
2. The lead for the horn (-) must be connected to the terminal of the speaker (-). Never
connect it to the car or to other speakers.
3. Switch on the unit after you make sure that all connetion is correct.
4. While changing the burnt fuse, please change the fuse of the same specification.
5. Pleade block up the vent or the board for heat dissipation so as not to lead to a fire due
to internal overheating of the unit.
6. After installation, you can start using the unit for your car (including the replacement of
batteries for your car). Please dismantle the front panel and then use sharp head tools
(other sharp matters are strictly prohibited) to press the RESET button on the base so
that the system is in the initial setup state.
About these Operation Instructions
This unit has a series of superior functions to ensure the efficient reception and operation.
All these functions are designed for the simplification of operation. However, there are no
instructions for most of the functions. These operation instructions will help you to
understand the performance operations of this product.
These operation instructions mainly introduce the operation of the remote control. Some
functions relationg to the operations of DVD/VCD/CD/MP3 can only be implemented by
the remote control. But some functions can also be implemented by the host.
WIRING DIAGRAM
This product collocates ISO connector, please connnect correctly follw the instruction
Grey/ Grey black-right front speaker anode/cathode
Wite /White black-left front speaker anode/cathode
Green/Green black-left rear speaker anode/cathode
Green/Green black-left rear speaker anode/cathode
Red-ACC ON(+12V)
Yellow-battery anode(+12V)
Black-ground wire
Blue-power antenna control wire
Line output-white/red left/right track
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eonon E1095 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eonon E1095 in the language / languages: English as an attachment in your email.

The manual is 1,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info