Manual Enviracaire EWM-350 (page 5 of 32) (English, French, Spanish)

603995

Zoom out

Zoom in

1/32

REFILL INDICATOR ( )- When illuminated, the water tanks need relling.See the

section “Filling the Water Tank”. If still illuminated a few minutes after full tank is placed

on base, reposition water tanks. (Unit will operate with only one water tank.) Each

time you ll tanks, rinse tanks, hot water reservoir and cold water reservoirs. Clean

them according to CLEANING INSTRUCTIONS if minerals or lm are present.

RELATIVE HUMIDITY CONTROL ( ) - This controls the humidity level. If moderate

humidity is desired, the control should be turned counterclockwise toward “LO”; and if

higher humidity is desired, clockwise toward “HI”.

NOTE: When you unpack your humidier, you may nd it has droplets of water on

some surfaces. This is normal as every unit is tested prior to shipping. Carefully unpack

humidier and remove all packing material.

OPERATING INSTRUCTIONS

1. Place the base of the unit on a rm, at, level and water resistant surface.

2. Fill the water tanks according to the instructions below and place on humidier base.

3. Plug the power cord rmly and completely into the wall outlet.

4. Turn the power switch to either the LO or HI position (Lights may icker

momentarily). Then turn the relative humidity knob clockwise until you hear a faint

click and the power light comes on. It will be normal for the humidier to take a

few minutes to warm up and begin to mist.

5. When the water tanks are empty, (after approximately 36 hours running time), the

“REFILL WHEN LIT” lamp will go on, and the unit will stop heating. Refer to the

“FILLING THE WATER TANKS” section.

6. Whenever the water falls below the level of the probes during operation, the

heating element will shut o and stop heating, and the REFILL indicator will light.

7. The unit will operate as long as there is water in either tank and unit will operate

with either one or both tanks.

FILLING THE WATER TANKS

1. Before lling the water tanks, turn the POWER switch to the “OFF” position and

unplug unit. Refer to cleaning instructions.

2. Remove water tanks from base, turn each tank upside down and remove tank cap

by turning counterclockwise. Fill tank with clean cold tap water.

If using distilled water, add a few grains of table salt to each tank.

Replace the tank cap by turning clockwise. Tighten rmly.

3. Carefully pick up tank, since it will be heavy when full, and slippery if wet.

4. Place water tanks on base. Make sure tanks are properly placed, otherwise, the

humidier will not work correctly.

EWM-300W-350_OM.indd 5 3/26/07 2:58:04 PM

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Enviracaire EWM-350 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,93 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Enviracaire EWM-350 Manual

Product: