• Remove the water tank by grasping handle and
pulling straight up. Set aside (Fig. 1).
• Lift up on the motor housing to remove and set aside
(Fig. 2). Remove the filter from the base before filling
the unit with water. Soak filter in a sink full of cool
water to help reduce mineral build up and place
back in the humidifier while wet. DO NOT SQUEEZE
OR WRING OUT THE FILTER. To help extend the life
of your filter repeat this step each time you fill your
humidifier.
• Turn the Water Tank upside down so that the Fill Cap
is facing up; unscrew the Fill Cap by turning it
counter-clockwise and set aside.
•
Fill the Water Tank with COOL tap water (Fig. 3).
Distilled water is not necessary as the water is filtered
by the filter.
DO NOT USE HOT WATER. Doing so may
damage the humidifier.
• Replace the fill cap by turning it clockwise .
DO NOT OVER TIGHTEN. Turn the Water Tank
right-side up.
NOTE: WHEN CARRYING THE FILLED WATER TANK
PLEASE USE THE HANDLE AND PLACE YOUR OTHER
HAND UNDER THE TANK FOR ADDITIONAL SUPPORT.
NOTE: We recommend that the humidifier be disinfected prior to first use. Please
see CLEANING instructions.
• Select a firm, level, flat location - at least six inches (15 cm) from any wall for
proper air flow (Fig. 1). Place the humidifier on a water-resistant surface, as
water can damage furniture and some flooring.
Kaz will not accept responsibility for property damage caused by
water spillage.
Fig. 1
Fig. 2
Fig. 3
WALL
6"
SETUP
FILLING
