Manual Enduro EM303 (page 39 of 56) (English, German, Dutch, French)

601368

Zoom out

Zoom in

1/56

ENDURO

EM303 34

Ref: EM303-UM-TKI-0115-Rev.A.

Dead and used batteries may leak and damage the remote control handset! Remove the batteries if the

handset is not going to be used for an extended period.

OPERATION - ELECTRONIC CONTROL UNIT

The electronic control unit (32), which is mounted inside your caravan, is responsible for controlling the

manoeuvring system.

The control unit has three LED’s, one pushbutton and one slide switch (Fig. 3):

Green LED (Fig. 3B): Power LED continuously illuminated

when system is activated (by moving slide switch to

“On”-I). If the handset far away from the control unit, beyond the availably distance, this LED will go out.

Blue LED (Fig. 3C): Error message LED concerning caravan battery:

 Blue LED is blinking (2 times blinking, break, 2 times blinking, break etc.): Battery voltage too low (<10V).

Battery needs to be recharged.

 Blue LED is blinking (4 times blinking, break, 4 times blinking, break etc.): Battery Voltage too high (over

charged). Try to discharge the battery by turning on a user (for example a lamp or water-pump).

Red LED (Fig. 3D) is blinking (6 times blinking, break, 6 times blinking, break etc.): Amp overload protection is

activated. Wait about 60 seconds and try again.

In general all error messages will reset automatically after one minute. If this is not the case, reset the

electronics of the manoeuvring system by switching off the system via the isolation switch and the remote

control handset for at least 15 seconds and then turning it on again.

The Reset Button (Fig. 3A): The remote control handset and the control unit are synchronised with each other

in the factory. If the control unit or the remote control handset is replaced, they must be re-synchronised as

described below:

 Check the installation in accordance with the installation instructions and ensure that the drive rollers are

not applied. Check that the battery is properly connected, check the condition of the battery and that a

voltage of 12 V is present at the control unit.

 Please ensure that the battery isolation switch is on.

 Activate the remote control handset by sliding the slide switch to “On”-I (Fig. 5A). The green LED on the

remote control handset (Fig. 5H) starts to flash slowly.

 Press the reset button (Fig. 3A) on the control unit. All three LED’s on the control unit (Fig. 3B, 3C & 3D)

will flash slowly.

 Press both forwards (Fig. 5B) and reverse (Fig. 5C) button on the remote control handset for about 3

seconds. Then the handset buzzer will give a short beep to confirm that the synchronisation is complete.

 After successful synchronisation, the green LED on the control unit (Fig. 3B) and on the remote control

handset (Fig. 5H) will illuminate continuously.

The single-twin axle function switch (Fig. 3S/T): The EN

DURO

EM303 caravan manoeuvring system is

suitable for both single axle and twin axle caravans. You just need to pull the single-twin axle function switch

(Fig 3S/T) on the control unit, so that the manoeuvring system can be used for a single-axle caravan or a twin-

axle caravan (for 2 motor use but also for 4 motor use). In the twin axle function the all wheels will drive but at

a different speed.

The switch standard pre-selected for single axle use (Fig 3S). For twin axle use, just move the switch to the

twin axle position (Fig. 3T). When move the single-twin axle function switch, the battery power isolation switch

(29) must be turned off.

OPERATION - GETTING STARTED

Please make sure you read the safety instructions very carefully and make sure that you

follow these guidelines!

Make sure that the battery that supplies the system is fully charged and in good condition.

Make sure that the caravan is free from the vehicle and the handbrake is on. Also make sure

that the corner steady feet are fully raised.

Fit the end socket of the engagement tool (6) onto the engagement spindle (Fig. 9) on the right or left hand

motor unit. This only needs to be done on one side of your caravan since the other side will automatically follow

via the cross actuation bar.

Turn the handle until it will turn no more without excessive force. The colour of the traction indicator label (Fig.

11A) should be into the green area

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Enduro EM303 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,66 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Enduro EM303 Manual

Product: