Manual Elro HIS20SF (page 5 of 62) (English, German, Dutch, French)

536726

Zoom out

Zoom in

1/62

QUICK SET

The system may be fully armed in 5 seconds using the

quick set facility, overriding the programmed exit-delay.

This is useful for setting the system at night when the

exit-delay warning beep will be silenced after just a few

seconds.

ZONE LOCKOUT

If a detector on an active zone is triggered while the

system is armed, an alarm condition will occur. After

the programmed alarm duration has expired, the alarm

will stop. If a single zone initiates an alarm condition

more than three times then that zone will be ‘Locked

Out’ and any further alarm signals from that zone will be

ignored until the system is disarmed.

Note: The ‘Zone Lockout’ feature can be disabled if

required.

EVENT LOG

The Smart Home Box incorporates a memory capable

of storing the last 100 system events. This enables

the user to see which user has Armed/Disarmed the

system and if and when any alarms occurred. The

time, date and details of the event type will be recorded

for each system event.

CHIME

Chime is a low security facility for use when the zone is

disarmed. If the Chime feature is ON, and a detector

on a zone that has its Chime function enabled is

triggered, the internal sounder will produce a low

volume warning tone. A typical use of the Chime

function would be to warn that a door or particular area

has been accessed.

VOICE DIALER

If the Voice Dialer is enabled and an alarm condition

occurs, the system will call for help using your recorded

alarm messages and up to ten telephone numbers.

When an alarm condition occurs, the telephone voice

dialer (if enabled) will call the first enabled number in

the calling sequence and replay the recorded alarm

messages for the configured ‘Play Time’. The recipient

must acknowledge the message by pressing the

button on their telephone keypad. If the call is

unanswered or an acknowledgment is not received

then the next active number in the dialing sequence will

be called. The dialer will continue calling each

number in turn until either all numbers in the sequence

have been dialed the set number of times or the

sequence is cancelled/acknowledged by the recipient.

DIGITAL DIALER

As an alternative to the Voice dialer the system may be

configured to interface with a central monitoring station.

LATCH KEY

When the system is disarmed the Latch-Key facility, if

enabled, will call the first latchkey phone number

among 10 phone number and replay the user message

(recorded under user setup) for the set ‘Play Time’.

The recipient must acknowledge the message by

pressing button on the telephone keypad.

The voice dialer will continue calling the first latchkey

phone number until it has been dialed the set number

of times when the following conditions occur:

1. The call is answered but the recipient does not press

on the telephone keypad for acknowledgement.

2. The call is unanswered or an acknowledgement is

not received.

For example, the latchkey facility is useful to inform

parents that a child has returned from school and

disarmed the system.

REMOTE SYSTEM CONTROL

It is possible to dial into the system via the connected

telephone line to interrogate the system status and to

have basic control over the system, (e.g. to Arm and

Disarm the system). You may also activate the

microphone on the Smart Home Box to Listen-In to

what is happening in the protected property.

TAMPER PROTECTION

All system devices (except the Remote Control Units)

incorporate Tamper protection features to protect

against unauthorized attempts to interfere with the

device. Any attempt to remove the battery covers from

any device (except the Remote Control) or to remove

the Smart Home Box from the wall will initiate an alarm

condition (unless the system is in Test or Programming

modes), even if the system is Disarmed.

JAMMING DETECTION

In order to detect any attempts to illegally jam the radio

channel used by your alarm system, a special jamming

detection function is incorporated into the Smart Home

Box and Solar Siren. If this feature is enabled, and the

radio channel is jammed continuously for 90 seconds,

when the system is armed, the Solar Siren will emit a

pre-alarm series of rapid bleeps for 3 seconds. If the

jamming continues for a further 30 seconds or more a

full alarm condition will occur. In addition if the system

is jammed for more than three periods of 30 seconds in

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Elro HIS20SF in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,79 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Elro HIS20SF Manual

Product: