708676
4
Zoom out
Zoom in
Previous page
1/4
Next page
4
7.
Perform the test using the same steps described in Operation & Testing section
above to ensure the unit is working properly. By walking into the protected area
with coverage of 110 degrees, the detector will now be triggered each time it
senses movement. Note that the detector can only be triggered once every 30
seconds when mounted on the wall.
Maintenance
Low Battery: When the battery becomes low, the LED will flash red when
motion is detected to indicate low battery condition to the user.
Troubleshooting
The troubleshooting table lists some possible causes and solutions. Please contact
your original retailer or nearest service center if the below solutions cannot solve
your problem.
Symptom
Cause of Failure
Recommendation
LED cannot be displayed
1.
Run out of battery
power.
2.
Check if reverse battery
polarity.
1.
Replace a new battery.
2.
Refit the battery with
correct polarity.
The detector is not working
1.
The PIR detector cannot
communicate with the
gateway.
2.
Check if the detector is
out of order.
1.
Place the PIR Detector
closer to the gateway.
2.
Send the device in for
repair and do not open it.
After the two-minute warm
up is completed, the
detector does not work
and LED flashes on and
off repeatedly at with an
interval of 2 seconds
1. Check if detector has
completed binding with
Gateway
1. Remove the battery and
follow the steps for
“Manual binding”.
Reset to Factory Settings
1.
Press and hold the link key on the PCB for 3 or more seconds, and the
detector LED will start to flash.
2.
Press and hold the link key for 6 or more seconds within 30 seconds until the
LED turns off. The device is now reset back to factory mode
Specifications
Battery
CR123A 3.0V 1700mAh Lithium Battery
Operating Temperature
-10°C to 40°C
Warm Up Time
About 2 minutes
PIR Detection Coverage
Wall-Mounted:
Up to 10m x 110
°
(at 1.8m mounting height & 25
°
C)
Operating Frequency
868MHz
** Specifications are subject to change without notice.
WARNING:
Do not dispose of electrical appliances as unsorted municipal waste, use separate
collection facilities.
Contact your local government for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health
and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to
take back your old appliance for disposal at least for free of charge.
A501112384R02
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro AS80PR11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro AS80PR11 in the language / languages: English as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info