708678

Elro AS80KE11 Manual

4
Zoom out
Zoom in
Previous page
1/5
Next page
4
1.
Undo and remove the fixing screw from the bottom edge of the Keypad and
remove the wall mounting plate (Figure 2).
2.
Using the mounting plate as a template, mark the positions of the two fixing
holes on the wall.
3.
Fix the mounting plate to the wall using the screws and wall plugs provided
(Figure 3). Do not over-tighten the fixing screws as this may distort or
damage the mounting plate.
4.
With batteries installed inside, slide the keypad into its wall mounting plate
and screw the fixing screw to secure it in place. Do not over-tighten the
screw.
Enabling/Disabling the Panic function
If the keypad is mounted outside of your home, e.g. in apartment hallway or
stairs, you may choose to disable the Panic function to prevent abuse by
strangers triggering an alarm condition in your home.
To do this you need to enter the keypad’s own administrator PIN code. This is
separate from the access code created under “Configuration” section.
Note: The default administrator PIN code is
1-2-3-4. It is recommended that
you change this to another four digit number. See the next section on how to do
this.
a.
Panic Disable:
Press administrator PIN code followed by “0”, e.g.
1-2-3-4-0
b.
Panic Enable:
Press administrator PIN code followed by “1”, e.g.
1-2-3-4-1
Note: the default setting is enabled.
Changing the Administrator PIN code
To change the Administrator password, press the following keys in sequence:
1.
Press current administrator code followed by “2”, e.g. 1-2-3-4-2
2.
Enter new administrator code followed by “2”, e.g. 8-8-8-8-2
If you have forgotten the administrator PIN code, refer to section “Reset to
factory” to reset the PIN code.
Maintenance
If the battery level becomes low, the low battery LED will flash 4 times when any
key is pressed. Batteries should be replaced as soon as possible by following
the steps below:
Note: Removing the keypad from its wall mount will trigger the tamper
protection switch and cause an alarm. Prepare a keyfob controller SR804 ready
to quickly disarm the system or use the App.
1.
Undo the fixing screw at bottom of keypad and remove it from the wall
mounting plate.
2.
Replace with three AA alkaline batteries.
3.
Refit and secure the Keypad onto the mounting plate.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro AS80KE11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro AS80KE11 in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info