133567

Elica mini om Manual

6
Zoom out
Zoom in
Previous page
1/6
Next page
8
INSTRUCTION ON MOUNTING AND USE
GB
appliances powered by other than electricity are used at the
same time. Flambé cooking with a cooker hood is
prohibited. The use of a free flame is damaging to the filters
and may cause fire accidents, therefore free flame cooking
must be avoided. Frying of foods must be kept under close
control in order to avoid overheated oil catching fire. Carry
out fumes discharging in accordance with the regulations in
force by local laws for safety and technical restrictions.
Installation - Fig. 5
Consult the designs in the front pages referenced in the text
by alphabet letters. Closely follow the instructions set
out in this manual. All responsibility, for any eventual
inconveniences, damagxes or fires caused by not complying
with the instructions in this manual, is declined.
The hood must be at a distance of not less than 40 cm from
the cooking top with electric plates.
If the instructions for installation for the gas hob specify a
greater distance, this must be adhered to.
The hood is supplied in the FILTERING version and is used
without an extracted fumes discharger conduit .
Fumes and steam are recycled through the F deflector (11F).
If you intend using the product in the SUCTION version, it
is necessary to have an evacuation conduit going from the
upper B exit to the extraction hole towards the exterior.
In this case a connection ring (11A) has to be installed on
the B extraction hole and the carbon filter removed.
A telescopic flue is available (as an accessory).
Preliminary information for installation of the hood
Expansion wall plugs are provided to secure the hood to
most types of walls/ceilings. However, a qualified technician
must verify suitability of the materials in accordance with the
type of wall/ceiling. The wall/ceiling must be strong enough
to take the weight of the hood.
Do not tile, grout or silicone this appliance to the wall.
Surface mounting only.
In the case of the presence of panels and/or walls and/or
lateral wall units check that there is sufficient space to install
the hood and that access to the command panel is easy.
Only for some models
An aesthetic flue can be purchased as an optional accessory.
Check with the assistance centre whether the model in your
possession envisages this possibility.
We advise installing the hood after having purchased the flue
to check with certainty the most suitable installation.
During electrical connection ensure the power supply is
disconnected at the domestic main switch.
• Trace a centre line on the wall to facilitate the montage
(1), position the hole template so that the middle line
printed on it corresponds to the centre line previously
drawn and that the lower side of the grill corresponds to
the lower part of the hood once mounted (2).
• Make two holes with the 8 mm Ø drill and fix the support
bracket with two dowels and wall screws (3).
• Open the steam screen and remove the grease filter (see
relative paragraph).
• Hang up the hood (4), adjust its position (5-6) and mark
1 point from the inside of the hood for the definitive fixing
(7). Remove the hood and make a Ø 8 mm hole with
the drill (8), insert the wall dowel and hang the hood up
again and fix it definitively with 1 screw (9).
• Connect the electricity (10), but leave the hood
disconnected from the general electric panel of the
house.
• Install the supplied flange (11A –suction version– also
install a discharge tube of suitable dimensions) or the
deflector (11F – filtering version).
• Mount the grease filter and close the steam screen.
Attention! If the hood is to be used in the suction version,
remove, if supplied with the kit, the carbon filter and the
fixing rods (on the back of the grease filter – see relative
paragraph).
If the hood is to be used in the filtering version, check that
the carbon filter is already mounted on the back of the
grease filter or, in its absence, purchase it and install it.
Electrical connection
The electrical tension must correspond to the tension noted
on the label placed inside the cooker hood. Connect the
electrical plug, where provided, to the an easily accessible
outlet in conformity with local standards in force.
Where an electrical plug is not provided (for direct connection
to electrical network) place a standards approved bipolar
switch with an aperture distance of not less than 3mm
(accessible) from the contacts.
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE). By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.
The symbol
on the product, or on the documents
accompanying the product, indicates that this appliance may not
be treated as household waste. Instead it shall be handed over
to the applicable collection point for the recycling of electrical and
electronic equipment. Disposal must be carried out in accordance
with local environmental regulations for waste disposal.
For more detailed information about treatment, recovery and
recycling of this product, please contact your local city office,
your household waste disposal service or the shop where you
purchased the product.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elica mini om at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elica mini om in the language / languages: English as an attachment in your email.

The manual is 0,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Elica mini om

Elica mini om Usermanual and installation guide - All languages - 100 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info