471220
8
Zoom out
Zoom in
Previous page
1/8
Next page
10
Description of the hood - Fig. 1
1 Control panel
2 Grease filter
3 Grease filter release handle
4 Halogen lamp
5 Vapour screen
6 Telescopic chimney
7 Air outlet (used for filter version only)
Operation
Description of control panel and hood operation
A. on/off light switch
B. on/off aspiration switch and minimum power
selection
B+C. medium power selection aspiration switch
B+D. maximum power selection aspiration switch
Use the high suction speed in cases of concentrated
kitchen vapours. It is recommended that the cooker
hood suction is switched on for 5 minutes prior to cooking
and to leave in operation during cooking and for another
15 minutes approximately after terminating cooking.
Maintenance
Prior to any maintenance operation ensure that the cooker hood is
disconnected from the power supply.
Cleaning
The cooker hood should be cleaned regularly internally and externally.
For cleaning use a cloth moistened with denatured alcohol or neutral
liquid detergents. Avoid abrasive detergents.
Warning:
Failure to carry out the basic standards of the cleaning of the cooker
hood and replacement of the filters may cause fire risks.
Therefore we recommend oserving these instructions.
Grease filter
This must be cleaned once a month using non aggressive detergents,
either by hand or in the dish-washer, which must be set to a low
temperature and a short cycle.
When washed in a dish-washer, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle (f) - (Fig.
2).
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
A
B
C
D
The charcoal filter can be washed once every two months using hot
water and a suitable detergent, or in a dish-washer at 65°C (if the
dish-washer is used, select the full cycle function and leave dishes
out).
Eliminate excess water without damaging the filter, then remove the
mattress located inside the plastic frame and put it in the oven for 10
minutes at 100° C to dry completely. Replace the mattress every 3
years and when the cloth is damaged.
Remove the filter holder frame by turning the knobs (g) 90° that affix
the chimney to the cooker hood (Fig. 3).
Insert the pad (i) of activated carbon into the frame (h) and fit the
whole back into its housing (j).
Replacing lamps - Fig. 4
Firstly check that the lamps are well cooled prior to replacing them.
Use a small screwdriver as a lever on the borders of the lamp in order
to remove the lightbulb.
Unthread the connector A.
Slide out the lightbulb to be replaced and replace with a new 12V
20W 30° Ø35 12V GU4 PHILIPS STANDARD LINE code 425409.
Carry out the replacement and mount the new lightbulb by following
instructions in the reverse.
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
Caution
This appliance is designed to be operated by adults. Children should
not be allowed to tamper with the controls or play with the appliance.
Do not use the cooker hood where the grill is not correctly fixed! The
suctioned air must not be conveyed in the same channel used for
fumes discharged by appliances powered by other than electricity.
The environment must always be adequately aerated when the
cooker hood and other appliances powered by other than electricity
are used at the same time. Flambé cooking with a cooker hood is
prohibited. The use of a free flame is damaging to the filters and may
cause fire accidents, therefore free flame cooking must be avoided.
Frying of foods must be kept under close control in order to avoid
overheated oil catching fire. Carry out fumes discharging in
accordance with the regulations in force by local laws for safety and
technical restrictions.
INSTRUCTION ON MOUNTING AND USEGB
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elica Menhir at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elica Menhir in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info