Manual Elica Glacier (page 5 of 5) (English, German, Dutch, French, Italian, Spanish)

471150

Zoom out

Zoom in

1/5

HOOD DESCRIPTION – Fig. 1

1. Control panel

2. Anti-grease filter

3. Halogenous lamps

4. Vapor screen

5. Telescopic stack

Description of the control panel and functioning of

the hood – Fig.1

a. operating gauge

b. on/off light switch

c. on/off aspiration switch and minimum power selection

d. medium power selection aspiration switch

e. maximum power selection aspiration switch

Use the high suction speed in cases of concentrated kitchen

vapours. It is recommended that the cooker hood suction

is switched on for 5 minutes prior to cooking and to leave

in operation during cooking and for another 15 minutes

approximately after terminating cooking.

Use: the hood is equipped with an upper B air exhaust pipe

for eliminating fumes towards the outside (Exhausting

version – exhaust pipe and fastening rings are not

supplied). In case of impossibility to direct fumes and

vapors towards the outside, a Filtering version of the hood

is available by installing an activated charcoal filter and the

deflector F on the stack support G, fumes and vapors are

recycled through the upper grate cleaner H by means of an

exhaust duct connected to the upper air exhaust B and the

connecting ring mounted on the deflector F (exhaust duct

and fastening bails are not supplied).

The models without suction motor operate only in the suction

version and must be connected to a peripheral suction unit

(not supplied).

Installation: The cooker hood must be placed at a

minimum distance of 60 cm from the cooking plane for

electric cookers and 70cm for gas or mixed cookers.

The vapor screen to insert and affix (operation 18 in the

installation scheme) may be of different forms, but the

assembly remains identical. Lock in the screws that affix

the vapor screen to the cooker hood (operation 18 in the

installation scheme).

Do not tile, grout or silicone this appliance to the wall.

Surface mounting only.

Do not fix chimney flue to furniture or fly over shelves

unless the chimney flue can be easily removed, in case

maintenance is ever required.

Electrical connection: The electrical tension must

correspond to the tension noted on the label placed inside

the cooker hood. Connect the electrical plug, where

provided, to the an easily accessible outlet in conformity

with local standards in force.

Where an electrical plug is not provided (for direct connection

to electrical network) place a standards approved bipolar

switch with an aperture distance of not less than 3mm

(accessible) from the contacts.

Caution: This appliance is designed to be operated by

adults. Children should not be allowed to tamper with the

controls or play with the appliance.

Do not use the cooker hood where the anti-grease filter is

not correctly fixed! The suctioned air must not be conveyed

in the same channel used for fumes discharged by

appliances powered by other than electricity. The

environment must always be adequately aerated when the

cooker hood and other appliances powered by other than

electricity are used at the same time. Flambé cooking with

a cooker hood is prohibited. The use of a free flame is

damaging to the filters and may cause fire accidents,

therefore free flame cooking must be avoided. Frying of

foods must be kept under close control in order to avoid

overheated oil catching fire. Carry out fumes discharging

in accordance with the regulations in force by local laws for

safety and technical restrictions.

Maintenance

Prior to any maintenance operation ensure that the

cooker hood is disconnected from the electrical

outlet.

Anti-Grease filter: it must be cleaned once a month, using

non-aggressive detergents, manually or in the dish-washer

at low temperature and brief cycle. In order to remove the

anti-grease filter, pull the spring handle f downwards –

(Fig.2). When washed in a dish-washer, the grease filter

may discolour slightly, but this does not affect its filtering

capacity.

Charcoal filter (only in the filtering version)

It absorbs unpleasant odors caused by cooking.

The charcoal filter can be washed every two months using

hot water and appropriate detergents or in the dish-washer

at 65° C (if the dish-washer is used, select the full cycle

function and leave dishes out).

Eliminate excess water without damaging the filter, then

remove the mattress located inside the plastic frame and put

it in the oven for 10 minutes at 100° C to dry completely.

Replace the mattress every 3 years and when the cloth is

damaged.

Remove the frame i which supports the filter h by

unscrewing it from the hood g (Fig.3). Insert the coal

mattress inside the frame and put all parts back in their place.

Cleaning: the hood must be cleaned regularly both

internally and externally. Use a damp cloth with denaturated

alcohol or neutral liquid detergents. Avoid the use of

abrasive products.

Ignoring the procedure for the cleaning of the hood, the

replacement and cleaning of the filters can lead to fire risk.

Replacement of lamps

Remove the light bulb from the lamp using a small screw

driver as a lever on the borders. (Fig. 2) Replace the light

bulb with a new PHILIPS STANDARD LINE code 425409

of 12V 20W 30° Æ35 12V GU4.

After the replacement of the light bulb follow instructions in

reverse to close lamp housing.

Closely follow the instructions set out in this manual

All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in

this manual, is declined.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Elica Glacier in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Elica Glacier Manual

Product: