633192

Elektra Nu-Vista CD - Musical Fidelity Manual

15
Zoom out
Zoom in
Previous page
1/17
Next page
Page 15
Basic problem-solving with a CD player is similar to troubleshooting other electrical or electronic equipment. Always check the most
obvious possible causes first, such as the following examples:
Problem Probable Cause Remedy
No power / display Power plug is not inserted into socket correctly Plug in securely into unit’s IEC socket.
No playback when disc is
loaded, “NO DISC” displayed
Disc is loaded with label side down
Incorrect disc type
Dirty disc
Moisture/humidity or cold affecting laser lens
Re-load with label side up
Please load a standard audio CD
Clean disk and try again
Leave unit on for an hour to allow moisture to
evaporate.
No audio output, or output too
low
Incorrect or missing connections Check connections are secure.
No Display Power not on/connected
Display set to “off”
Check mains lead is connected and blue LED
is lit by pushing “PWR/STBY” button.
Press “DISPLAY” button to reactivate display.
Hum Audio connector plug not fully pushed in
Cable Fault
Unsuitable Cable
(e.g. cable grounds not connected)
Insert plug securely
Check cable is connected at both ends.
N.B. some esoteric cables have internal wiring
intentionally disconnected/modified. For best
results on all inputs analogue AND digital,
please use good quality screened coax; signal
and screen directly connected both ends.
Mistracking (sound jumping) Player is receiving vibration or shock
Disc is dirty
Moisture/humidity or cold affecting laser lens.
Move player away from loudspeakers etc.
Clean disc surface
Leave unit on for an hour to allow moisture to
evaporate.
Dropouts in sound Digital input lead not properly connected
Faulty digital input lead
Faulty optical lead
Check input lead is fully secured
Change lead. Please use a good quality
straight-through signal-and-ground phono to
phono lead.
Optical lead breakage. This can occur if the
optical lead is bent into a radius too small.
Avoid tight corners in routing optical leads.
Digital input not working No connection to that input
Incorrect input selected
Wrong data type sent to DAC
Check connection and cable.
Select correct input
Check source digital output is set for “16 bit
stereo PCM” or similar. This particularly
applies to some TVs, most DVD players, and
other home theatre type devices that may give
a MULTICHANNEL digital output. Refer to the
source equipment manual for further
information.
Remote control range has
reduced
Batteries are flat Change batteries for a new set
Control is not pointed directly towards the front
panel of the player
Ensure there is no obstruction between the
remote control and player front
Batteries are running out Change batteries – for a new set
If none of these actions affect a cure, please contact the dealer, or an authorised Musical Fidelity service agent. Remember;
never open the case of the Nu-Vista CD, as this will invalidate the guarantee.
PROBLEMS?
… 15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elektra Nu-Vista CD - Musical Fidelity at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elektra Nu-Vista CD - Musical Fidelity in the language / languages: English as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info