580176
4
Zoom out
Zoom in
Previous page
1/8
Next page
4
Connect the Programming Keypad (EL2635-P) to the Programming
Keypad
(EL2635-P) connector.
Note: The Programming Keypad (EL2635-P) is not able to operate on
battery
power only.
8.
Test the repeater from the required mounting location before permanently
mounting the unit.
9.
Mount the base to the wall using four screws and replace the front cover.
When the tamper switch is open, the bi-
color LED provides indication regarding
repeater transmission and reception as
an aid during the installation procedure
see Table 1. When the tamper switch
is closed, the bi-color LED provides
indication regarding power status see
Table 2.
Table 1: LED Indication (Tamper Open)
LED Indication
Description
Steady Green
AC & Battery OK
Flashing Red
AC Loss
Flashing Orange
Low Battery
Table 2: LED Indication (Tamper Closed)
REGISTERING THE REPEATER TO
THE CONTROL PANEL
For the control panel to recognize the repeater, you
must register the repeater to the control panel.
To register the repeater to the control panel:
1.
Set the control panel to Registration mode
as follows:
From the Programming menu, select
Devices, Repeaters [914].
Select the repeater you want to register
(1-4).
From the repeater’s sub-menu, select
Register [#1].
2.
Send two Status transmissions from
the
repeater as follows:
On the Programming Keypad (EL2635-P),
press ... until 5. STS Transmit appears on
the display.
Press ./.
Press ./ again.
Figure 3: LCD rogramming
Keypad (EL2635-P)
LED Indication
Description
Flashing Green
Signal Reception
Flashing Red
Signal Transmission
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electronics Line EL2635 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electronics Line EL2635 in the language / languages: English as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Electronics Line EL2635

Electronics Line EL2635 User Manual - German - 6 pages

Electronics Line EL2635 User Manual - Dutch, French - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info