5. Technical data
Voltage 230V ~ 50Hz
Power consumption 600 W
Cutting length 530 mm
Cutter rail length 600 mm
Tooth spacing 20 mm
max. cutting ø 15 mm
Cuts/min 3200
Sound pressure level L
pA
84.7 dB(A)
Sound power level L
WA
99 dB(A)
K uncertainty 2.5 dB(A)
Vibration a
hv
6.5 m/s
2
K uncertainty 1.5 m/s
2
Weight 4,0 kg
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
Warning! The electric power tool generates an
electromagnetic field during operation. Under certain
circumstances this field may actively or passively
impede medical implants. To reduce the risk of
serious or fatal injuries, we recommend persons with
medical implants to consult their doctor and the
manufacturer of the medical implant prior to using the
equipment.
6. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Rotary rear handle (Figures 2-4)
The hedge shears are fitted with a rear rotary handle.
This can be turned counter-clockwise through 90°
and clockwise through both 90° and 180°. For this
purpose the top slide (Fig. 2/Pos. 1) must be pushed
backwards in the direction indicated by the arrow.
Then pull the slide (E) in the direction indicated by
the arrow and turn the handle. If you turn it counter-
clockwise the handle will lock at an angle of 90° (Fig.
3). If you turn it clockwise the handle will lock at an
angle of 90° and 180° (Figure 4). Pull the slide (E) in
the direction indicated by the arrow again to return
the handle to its original position. When the handle is
back in its standard position the top slide (E) must be
pushed forward to lock it.
For vertical cutting the handle should be set to 90°
and for overhead cutting it should be set to 180°.
Fitting the cuttings collector (Figure 5a-5d)
For horizontal cutting we recommend that you fit the
cuttings collector. This enables you to remove the
cuttings easily. The surface of the hedge thus
remains clear (Figure 5a/5b). Position the cuttings
collector on the cutter rail (Figure 5c). Then push the
cuttings collector as far as possible towards the tip of
the cutter rail. Ensure that the front tip of the cuttings
collector is pushed into the tip of the cutter rail. Then
tighten the fastening screws (10) securely (Figure
5d). The cuttings collector can be fitted on either the
right or left side.
11
GB
