644150
31
Zoom out
Zoom in
Previous page
1/60
Next page
31
Deutsch Español Slovensky
GEBRAUCH UTILIZACIÓN POUŽITIE
Wenn ein Fremdkörper getroffen wird oder bei Auftreten
starker Vibrationen muss das Gerät sofort abgestellt
werden. Trennen Sie die Zündspule von der Zündkerze.
Prüfen Sie, ob das Gerät beschädigt wurde. Eventuelle
Beschädigungen reparieren.
Wenn während der Arbeit etwas in den Messern hängen
bleibt, stellen Sie den Motor ab und warten Sie, bis er
vollkommen stillsteht, bevor Sie die Messer reinigen.
Trennen Sie die Zündspule von der Zündkerze.
Tragen Sie zur Reparatur der Schneidgarnitur immer
Schutzhandschuhe (Abb. 45), denn sie ist extrem scharf
und kann leicht Schnittverletzungen verursachen.
Lassen Sie den Gashebel los, sobald Sie mit der
Schneidarbeit fertig sind, und lassen Sie den Motor mit
Leerlaufdrehzahl laufen. Der Betrieb der Heckenschere mit
Motor bei voller Drehzahl aber ohne Schneidlast kann zu
unnötigem Verschleiß oder zur Beschädigung des Messers
und des Motors führen.
Wenn dicke Äste oder sonstige Gegenstände in den
Messern hängen bleiben, muss der Motor abgestellt
werden, bevor versucht wird, die Messer zu befreien.
Bewahren Sie einen sicheren Halt (B, Abb.46) an der
Heckenschere solange der Motor läuft. Griff so umfassen,
dass sich die Finger oben und die Daumen unten
befinden.
Hinweis: Sie können die Heckenschere auch ohne Griff
benutzen. Bauen Sie in diesem Fall den Griff ab und halten
Sie bei der Arbeit die vordere Hülse (C, Abb. 47) stets mit
der linken Hand fest.
VORSICHT! - Legen Sie das Gerät mit abgestelltem
Motor und gemäß Hinweisen in Abb. 48 auf den
Boden ab.
Schneidsaison
Befolgen Sie sämtliche Normen und nationalen und örtlichen
Bestimmungen über Heckenscheren.
Si golpea un cuerpo extraño o nota fuertes vibraciones,
detenga inmediatamente el aparato. Desconecte el cable
de la bobina de la bujía. Compruebe que el aparato no
esté dañado. Haga reparar los eventuales daños.
Si la cuchilla se bloquea durante el trabajo, apague el
motor y espere a que se detenga por completo antes de
limpiar la cuchilla. Desconecte el cable de la bobina de la
bujía.
Utilice siempre guantes de protección individual cuando
repare el grupo de corte (fig. 45) para evitar el riesgo de
corte.
Suelte la palanca del acelerador nada más terminar el
corte y mantenga el motor al mínimo. Si mantiene el
motor del cortasetos a pleno régimen sin carga de corte,
puede desgastar inútilmente, e incluso dañar, la cuchilla y
el motor.
Si alguna rama gruesa u otros objetos bloquean las
cuchillas, apague inmediatamente el motor antes de
intentar liberarlas.
Agarre firmemente (B, fig.46) el cortasetos mientras el
motor esté en marcha. Rodee la empuñadura con los
dedos y pase los pulgares por debajo de la empuñadura.
Nota: El cortasetos también se puede utilizar sin la
empuñadura. Para ello, desmontar la empuñadura y,
durante el trabajo, sujetar siempre con la mano izquierda
la zona de la funda delantera (C, Fig. 47).
PRECAUCIÓN - Apoyar siempre la máquina en el
suelo con el motor apagado y como se ilustra en la
Fig. 48.
Temporada de corte
Respete todas las normas nacionales y locales sobre
cortasetos.
Pri zasiahnutí cudzieho predmetu alebo v prítomnosti
silných vibrácií stroj okamžite zastavte. Odpojte
kábel cievky od sviečky. Skontrolujte, či stroj nie je
poškodený. Opravte prípadné škody.
Ak sa pri práci niečo zasekne medzi čepele, vypnite
motor a počkajte, kým sa úplne nezastaví, až potom
vyčistite čepele. Odpojte kábel cievky od sviečky.
Pri oprave rezacieho mechanizmu vždy noste
ochranné pracovné rukavice (obr. 45), pretože je
mimoriadne ostrý a mohli by ste sa ľahko porezať.
Uvoľnite plynovú páčku ihneď po ukončení rezu a
udržiavajte činnosť motora na minime. Ak necháte
krovinorez s motorom na plnom výkone bez rezania
materiálu, môže to spôsobiť zbytočné opotrebovanie
a poškodenie čepele a motora.
Ak sa čepele zaseknú v hrubých konároch alebo v
iných predmetoch, okamžite vypnite motor, ešte
predtým ako sa budete snažiť čepele uvoľniť.
Počas práce držte (B, obr.46) krovinorez dostatočne
silno. Prsty musia obopínať rukoväť a palec musí byť
oproti prstom, pod rukoväťou.
Pozn.: Krovinorez sa smie používať aj bez rukoväte.
V takom prípade odmontujte rukoväť a pri práci
vždy uchopte ľavou rukou oblasť prednej objímky
(C, obr. 47).
UPOZORNENIE! - Stroj vždy položte na zem s
vypnutým motorom, ako vidno na Obr. 48.
Sezóna rezania
Dodržiavajte všetky predpisy a vnútroštátne normy
týkajúce sa práce s krovinorezom.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Efco BC240HL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Efco BC240HL in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Efco BC240HL

Efco BC240HL User Manual - Dutch, Swedish - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info