644150

Efco BC240HL Manual

14
Zoom out
Zoom in
Previous page
1/60
Next page
14
1234
Italiano English Français
ASSEMBLAGGIO ASSEMBLY ASSEMBLAGE
MONTAGGIO ATTREZZO DI TAGLIO
1. Togliere il tappo (A, Fig.1)
2. Allentare le viti di serraggio (B, Fig.1) sul riduttore
del tagliasiepi ed inserirlo sul tubo di trasmissione,
ruotandolo un poco a destra e un poco a sinistra
(Fig.2). Quando l’estremità del tubo non è più visibile
nella fessura di serraggio (Fig.3) spingere il tubo in
avanti  no all’arresto.
3. Avvitare sino in fondo le viti di serraggio del
tagliasiepi (B, Fig.4).
MONTAGGIO IMPUGNATURA (Fig.5)
Montare l'impugnatura sul tubo di trasmissione e
ssarla tramite viti (A). La posizione dell'impugnatura e
registrabile in funzione all'esigenza dell'operatore.
CUTTING IMPLEMENT ASSEMBLY
1. Remove the plug (A, Fig. 1)
2. Loosen the clamp screws (B, Fig.1) of the
hedgetrimmer angle drive and couple to the end
of the shaft arm, twisting slightly one way and the
other (Fig.2). When the end of the arm can no longer
be seen through the clamp slit (Fig.3), push home
until it will go no further.
3. Tighten the clamp screws fully (B, Fig.4) to secure the
attachment.
FITTING THE HANDLE (Fig.5)
Fit the handle onto the shaft arm and secure it using
screws (A). The handle position is calculated depending
on the requirements of the operator.
MONTAGE DE L'OUTIL DE COUPE
1. Ôter le bouchon (A, Fig. 1)
2. Desserrer les vis de  xation (B, Fig.1) sur le réducteur
du taille-haies et monter ce dernier sur le tube de
transmission en le tournant légèrement à droite puis
à gauche (Fig.2). Lorsque l’extrémité du tube n’est
plus visible dans la fente de serrage (Fig.3), pousser
le tube en avant jusqu’à ce qu’il se bloque.
3. Serrer à fond les vis de fixation du taille-haies
(B, Fig.4).
MONTAGE DE LA POIGNÉE (Fig.5)
Montez la poignée sur le tuyau de transmission et  xez-
la avec les vis (A). La position de la poignée se règle
selon les exigences de l'opérateur.
OPERAZIONI PRELIMINARI PREPARING TO WORK PREPARATION
Cinghiaggio
Una corretta regolazione del cinghiaggio permette al
tagliasiepi di avere un buon bilanciamento ed una adatta
altezza dal terreno (Fig.6).
- Indossare il cinghiaggio.
- Agganciare il tagliasiepi al cinghiaggio tramite il
moschettone (B, Fig.7).
- Posizionare il gancio (C, Fig.7) per ottenere il miglior
bilanciamento del tagliasiepi.
- Posizionare la  bbia (D, Fig.8) per ottenere la corretta
altezza del tagliasiepi.
HARNESS
Correct adjustment of the harness makes it possible to
balance the tool correctly and set an appropriate height
from the ground (Fig.6).
- Put on the harness.
- Attach the hedgetrimmer to the harness by means of
the snap hook (B, Fig.7).
- Position the hook (C, Fig.7) to obtain the best
hedgetrimmer balance.
- Position the buckle (D, Fig.8) to obtain the correct height
of the hedgetrimmer.
HARNAIS
Un réglage correct du harnais assure l'équilibre du taille-
haies et le maintient à la bonne hauteur par rapport au
terrain (Fig. 6).
Toujours porter le harnais.
- Accrocher le taille-haies au harnais à l'aide du
mousqueton (B, Fig. 7).
- Placer le crochet (C, Fig. 7) de sorte à assurer l'équilibre
du taille-haies.
- Placer la boucle (D, Fig. 8) de sorte à porter le taille-haies
à la bonne hauteur.
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Efco BC240HL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Efco BC240HL in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Efco BC240HL

Efco BC240HL User Manual - Dutch, Swedish - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info