547014
22
Zoom out
Zoom in
Previous page
1/23
Next page
22
button has been pressed.
Under normal battery conditions the LED will
extinguish when the button is released.
Motion Sensors
Under low battery conditions the LED behind the
sensor lens will flash when movement is detected to
indicate that the battery needs to be replaced.
Under normal battery conditions the LED does not
illuminate unless the Motion Sensor is in Walk Test
mode.
Door/Window Contact Detectors
Under low battery conditions, when the Detector is
activated the transmit LED will be illuminated for
approximately 1s as the door/window is opened.
Under normal battery conditions the LED will not
illuminate as the Detector is operated, (unless the
Detector is in Test Mode with the tamper switch not
being pressed).
MAINTENANCE
Your Alarm System requires very little maintenance.
However, a few simple tasks will ensure its continued
reliability and operation.
CONTROL PANEL
The new batteries have a typical life of 2 years and
need no maintenance during this period. The
batteries will be damaged if they are not in use for long
periods.
DETECTORS AND REMOTE
CONTROLLER
The Detectors require very little maintenance. The
batteries should be replaced once a year or when a low
battery status is indicated.
IMPORTANT: Should you, for any reason, have to
completely power-down the system (e.g. to move the
system to a new premises) first put the system into Test
mode before removing the Control Panel from the
mounting bracket and disconnecting the power supply.
BATTERIES
Before removing the battery cover on any device to
replace the battery, ensure that the system is put into
Test mode to avoid initiating an Alarm.
The specifications for replacement batteries are as
follows:
Remote
Controllers
1 x 3V CR2032 Lithium Cells
(or equivalent)
Door/Window
Contact
Detectors
3 x 1.5V AAA Size alkaline
battery (or equivalent)
Motion Sensors 3 x 1.5V AA Size alkaline
battery (or equivalent)
At the end of their useful life the batteries should be
disposed of via a suitable Recycling Centre. Do not
dispose of with your normal household waste. DO
NOT BURN.
TROUBLESHOOTING
Forgot password
1. Remove Control Panel from the wall, set
Control Panel in test mode as prerequisite.
2. Remove all power sources from the Control
Panel, such as batteries and DC jack.
3. Move the pin of jumper link to reset position and
reconnect batteries or DC jack.
4. After refitting batteries, the Green statut LED
will turn on for three second indicating the
Control Panel is powered up. When LED turns
off, it implies initial power up is successful. Start
operating the Control Panel.
5. The default password is 1234.
6. Move the pin of jumper link to its original
position.
7.
All of settings will be reset including password,
telephone number and ID codes.
Control Panel not reacting to remote controller
or keypad
Restart learning ID code.
Control Panel not reacting to Motion Sensor(s)
and Door/Window Contact Detector(s)
Restart learning ID code.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eden HA700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eden HA700 in the language / languages: English as an attachment in your email.

The manual is 1,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Eden HA700

Eden HA700 User Manual - German - 29 pages

Eden HA700 User Manual - French - 29 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info