Manual Ebac 6000 Series (page 4 of 6) (English)

657257

Zoom out

Zoom in

1/6

To ensure continued performance from your Ebac 6000 the filter should be changed every 3 months.

A red light on the control panel will illuminate when the container is full, an audible alarm will also sound (if activated).

When this occurs water collection stops. When nearly full the indicator will flash a few hours before the container fills and

again the audible alarm will sound. It is advisable to empty the water container if the unit will be unattended for more

than a few hours to ensure the container doesn’t become full and the unit switch off whilst you are away. Once full the

unit will remain off until the container has been emptied and replaced.

To empty, open the water container

access door

The container can then be removed

and emptied as shown

Replace the container back into the

dehumidifier with the outlet on the

left hand side and gently close the

access door. The dehumidifier will

also switch itself off while the

container is removed.

Your Ebac 6000 has a filter system to remove dust from the air. This requires cleaning and we recommend that the

filter(s) be inspected every 4 weeks. Failure to do so will reduce the efficiency of your Ebac 6000. To clean, proceed

as follows:

Remove the filter(s) by removing the

filter covers

Remove the filter and clean with a

vacuum cleaner on a low power.

To refit, place the filter material back

into the holder(s) and replace onto the

unit

Boost Control

Ebac 6000 models have a boost control that increases performance of the unit in damp conditions. When activated

this increases the fan speed and operating mode to maximum for eight hours. This is particularly useful for periods of

high humidity such as drying laundry indoors or just after bathing. After this time the unit will return to the settings

you had prior to activation.

Fan only / Air cleaning mode

Ebac 6000 models are fitted with a fan only/air cleaning option. Select this mode if you want the fan to run all the time

without the dehumidifier operating. This is particularly useful during the summer to provide a fan facility and for air

filtration.

Audible container full alarm

Your Ebac 6000 is fitted with an audible alarm which beeps approximately every minute once the container is full. This

can be activated by pressing down the MODE button for 5 seconds until a beep is heard. You can de-activate this at

any time by again pressing down the MODE button for 5 seconds until a beep is heard.

Fan speed control

You may wish to change the fan speed of your Ebac from time to time. Using the Normal setting will remove more

moisture from the air compared to the Quiet setting thereby improving efficiency. When switched on your

dehumidifier will default to Normal.

Setting Function

Light not illuminated Normal setting

Light illuminated Quiet setting

Your Ebac 6000 will collect excess moisture either as condensed water or ice on the heat exchanger located inside the

unit. Any accumulation of ice is cleared periodically. Your Ebac 6000 incorporates a Defrost System which selects the

correct defrost mode for your home. This maximises the efficiency of the unit at temperatures between 3°C / 37°F and

35°C / 95°F

Setting the controls Emptying the water container

Cleaning the filter

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ebac 6000 Series in the language / languages: English as an attachment in your email.

The manual is 0,12 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ebac 6000 Series Manual

Product: