704381

Easymaxx Z05592 Manual

4
Zoom out
Zoom in
Previous page
1/8
Next page
4
Before fi rst use
• Unpack the product and remove any protective foils and
stickers. Check that the product contents are complete and
that they do not exhibit any transport damages. Should you
identify any transport damages, please promptly consult cus-
tomer service.
• Insert batteries (see sectionn “Inserting/changing batteries”)
• Before fi rst use, test the product to make sure that it is func-
tioning properly: To do so, move the ON/OFF switch to the
ON position. Place the motion detector in a dark room and
test it by e.g. waving your hand in front of the motion sensor. If
the LEDs do not illuminate, check whether the batteries have
been inserted correctly or insert a new set of batteries. If the
motion detector responds to your movement, you can mount
the product as described in the “Mounting” section.
Inserting/changing batteries
1. Use a cross-slot screwdriver to unscrew the battery compart-
ment and take the battery compartment cover off.
2. Take out all the used batteries.
3. Insert 4 new type AA 1.5 volt batteries. When you insert the
batteries, make sure the polarity is correct (+/-).
4. Place the battery compartment cover on the battery compart-
ment and screw it into place.
Mounting
ATTENTION!
❐ The motion detector only works in dark environments.
For this reason, only set up the motion detector in low-
light areas!
An adhesive strip for mounting the motion detector is included
in the product contents. Proceed as follows to mount the motion
detector.
1. Select a suitable location where you would like to mount the
motion detector. Make sure that the bottom is clean and dry
to ensure that the adhesive strip is able to stick to it properly.
2. Remove the protective fi lm from one side of the adhesive
strip.
3. Affi x the strip to the bottom of the rotatable base of the motion
detector.
4. Remove the second protective fi lm of the adhesive strip.
5. Mount the LED motion detector on a clean, dry surface by
placing it on the surface and pressing it fi rmly for approximately
30 seconds.
NOTE: You can also mount the product with screws or nails.
Slots for hanging the product on screws or nails are located on
the bottom of the rotatable base. However, no fastening mate-
rial such as screws or nails is included in the product contents.
Inquire at a specialised dealer as to which fastening material is
suitable for hanging up the product.
Start-up
1. Turn the product on by moving the ON/Off switch on the back
of the product to the ON position.
2. Then align the motion detector:
– The base of the motion detector can be rotated 360°. Turn
it to the desired position.
– The LED light can be tilted. Move it to the desired position.
3. The LED lights will illuminate as soon as it is dark enough and
the motion detector recognizes movement.
Cleaning and storage
ATTENTION! Do not use corrosive or abrasive cleaning
products or cleaning pads for cleaning the product.
• If necessary, clean the product with a damp cloth and wipe it
off with a dry dust cloth.
• If you do not intend to use the product for a prolonged period
of time, turn it off by moving the ON/OFF switch to the OFF
position and store it in a clean and dry place that is not
accessible for children and animals.
Technical data
Model number: H13073
Product number: Z 05592
Power supply: 6 volt DC
(4 x type AA 1.5 volt batteries)
Disposal
The packaging material is recyclable. Dispose of the
packaging in an environmentally-friendly manner and
make it available to the collection service for recyclable
materials.
Dispose of the product in an environmentally-friendly
manner. The product does not belong in the household
garbage. Dispose of it at a recycling centre for old
electric and electronic equipment. For more information,
please contact the administration in your community.
Batteries must be removed and disposed of separately
before disposing of the product. To protect the
environment, batteries may not be disposed of together
with normal household waste. Instead they must be
turned in at collection points. Please also observe
applicable statutory provisions regulating the disposal
of batteries.
Customer service/importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany
Tel.: +49 38851 314650 *)
*) Calls subject to a charge.
All rights reserved.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Easymaxx Z05592 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Easymaxx Z05592 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info