Manual Easymaxx Z04791 (page 3 of 6) (English, German, Dutch, French)

703727

Zoom out

Zoom in

1/6

EN Instructions

Customer Service / Importer:

DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •

✆ +49 38851 314650 *)

*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.

■ Use only the battery type speciﬁ ed in the “Technical Data”.

■ Take batteries out of the article when they are dead or if the

article is not going to be used for a prolonged period. This will

prevent any damage if a battery leaks.

■ Batteries must not be recharged or reactivated by other means,

dismantled, thrown into a ﬁ re, immersed in ﬂ uids, or short-cir-

cuited.

■ Protect the article from: impacts, heat, direct sunlight, sub-zero

temperatures, moisture and wet conditions.

■ Do not place any containers ﬁ lled with liquid, for example vas-

es, directly next to the article.

■ The article should not be operated via a computer, because the

high charging current could damage the computer.

■ Make sure that the USB cable does not become squashed or

bent and does not come into contact with hot surfaces.

■ Do not make any changes to the article and do not attempt to

repair it. In the event of any damage, please contact our cus-

tomer service department. The individual LEDs cannot be re-

placed.

Items Supplied

• LED Lantern

• USB cable (A connector to barrel connector)

• Instructions

Inserting / Changing Batteries

Insert three 1.5 V batteries, C, Baby type into the battery

compartment on the back side of the lantern before you

ﬁ rst use it. These are not supplied with the article.

Before inserting the batteries, check whether the contacts are

clean and clean them if necessary.

1. Open the battery compartment: Grip and press down the lock-

ing lug on the battery compartment cover. Lift up the cover at

the same time.

2. Insert three 1.5 V batteries of the C, Baby type into the battery

compartment. Ensure the correct

polarity (+ / –).

3. Reattach the battery compartment cover and press it shut.

When you do this, make sure that the locking lugs sit in the

recesses which are provided for them. You must hear and feel

it engage.

Replace the batteries when the power of the lights starts to wane.

PLEASE NOTE! Always replace all batteries together. Do not use

batteries of different types or brands, or batteries with different

capacities.

Putting Into Operation

1. Unpack – Check the items supplied for completeness (see

the “Items Supplied” section) and possible transport damage.

If you ﬁ nd any damage to the components, do not use them (!),

but contact our customer service department.

2. Set up – Set the article up on a ﬂ at, dry surface.

3. Insert batteries / use USB cable – Insert batteries into the

article (see the “Inserting / Changing the Battery” section).

If the article is to be operated with the USB cable, connect the

end with the barrel connector to the barrel connector input on

the article and connect the other end with the USB connector to

a power source, e.g. via a suitable mains adapter that supplies

at least 1 A (not supplied with the article) at a plug socket.

4. Switch on / off – To switch on the article, press the On / Off

switch on the back side of the article to position I.

To switch the article off again, press the On / Off switch to posi-

tion 0.

The article switches off automatically after 6 hours. It can

be switched on again at any time by pressing the On / Off

switch twice (position 0 → position I).

Cleaning and Storage

NOTE!

■ Under no circumstances should you use any corrosive or abra-

sive cleaning agents, rough sponges or knives to clean the

article. These could damage the surfaces.

1. Disconnect the article from the USB cable or take the batter-

ies out of the article (see the “Inserting / Changing the Battery”

section).

2. Clean the article with a soft cloth and a little mild detergent if

necessary.

3. Thoroughly dry the article before it is stored away.

4. Store the article in a dry place that is protected from sunlight

and is not accessible to children and animals.

Technical Data

Voltage:

4.5 V DC

(3 x 1.5 V batteries, C, Baby type)

Variations

Article number Dimensions Model number

04790 15 x 15 x 25 cm B2578

04791 30 x 18 x 31.5 cm B2575

Disposal

Dispose of the packaging material in an environmentally

friendly manner and take it to a recycling centre.

Dispose of the article in an environmentally friendly manner

at a recycling centre for used electrical and electronic

devices. More information is available from your local

authorities.

Batteries should be removed prior to disposal of the article

and disposed of separately from the article at suitable col-

lection points.

Z 04790_04791 M DS V1 0318

Article number: 04790 / 04791

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Easymaxx Z04791 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,3 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Easymaxx Z04791 Manual

Product: