703770

Easymaxx Z04117 Manual

4
Zoom out
Zoom in
Previous page
1/8
Next page
EN Instructions
Customer Service / Importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
✆ +49 38851 314650 *)
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
All rights reserved.
Setting Drill Holes
6. If the position is correct,
use a suitable drill and an 8 mm drill bit
to drill the marked holes with a minimum depth of 85 mm.
Taking the Article Apart for Mounting
7. Unscrew the stainless steel bolt using the hexagon key wrench,
remove the snap cover from the screw-on block and take the
spreading spring with the securing tube out of the screw-on
block.
Screwing Tight
8. Insert the dowels into the drill holes.
9. Depending on the gap size, screw tight the screw-on block or
the packing plate and the screw-on block using the counter-
sunk screws and the Torx bit TX25, if necessary use a bit exten-
sion if the Torx bit TX25 is not long enough.
The packing plate is used as a spacer from a gap size of
> 4 cm. In the case of gap sizes up to max. 4 cm, the pack-
ing plate is not used.
Attaching the Snap Cover
10. Place the spreading spring (with securing tube) into the guide
rail in such a way that the stainless steel bolt with the washer
can be plugged through the round opening of the spreading
spring.
11. Place on the snap cover.
12. Plug the stainless steel bolt with the washer into the drill hole
without a thread in the snap cover and gently tighten it with the
aid of the hexagon key wrench.
The securing tube may only be removed from the spread-
ing spring after the mounting of the snap cover has been
completed!
Use
The article is now activated and the window can no longer be
opened without activating the article at the same time.
To open the window, press the snap cov-
er towards the wall.
When the window is closed, the article
automatically snaps into the securing po-
sition.
To protect the window frame:
– stick one or two small felt pads on
the inside of the window sash at the
level of the article. These act as a
sliding surface between the article and
window frame.
– stick two rubber buffers onto the front
surface (A) of the snap cover (1)
(contact surface with window sash).
For further information: www.fenster-schnapper.de
Cleaning and Storage
CAUTION!
■ Do not use any corrosive or abrasive cleaning agents! They
could damage the surface.
• If the article is dirty, clean it with a damp cloth and mild deter-
gent if necessary.
Technical Data
Article number: 04117
Size:
– Length approx. 10 cm
– Width approx. 7.5 cm
– Height opened: approx. 6 cm
– Height opened with packing plate: approx. 7.5 cm
– Height folded up: approx. 2.5 cm
– Height folded up with packing plate: approx. 4 cm
Size installed:
– Gap size 2.5 cm - 4 cm
– Gap size with packing plate 4 cm – 5,5 cm
– Spatial depth (reveal) at least 10 cm
Pressure resistance: Test load > 20,000 N
(equivalent to a load of approx. 2000 kg)
Disposal
The packaging material is recyclable. Dispose of the pack-
aging and the article in an environmentally friendly manner
and take them to a recycling centre.
Z 04117 M DS V1 0717
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Easymaxx Z04117 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Easymaxx Z04117 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info