Manual Easymaxx Z03037 (page 3 of 6) (English, German, Dutch, French)

703730

Zoom out

Zoom in

1/6

EN Instructions

Customer Service / Importer:

DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany • ✆ +49 38851 314650 *)

*) Calls subject to a charge. Costs vary depending on the provider.

■ Do not place any containers ﬁ lled with liquid, for example vas-

es, on or directly next to the article.

■ Never immerse the article in water or other liquids! It is only

protected against splashing.

■ Never touch the article with damp or wet hands.

■ Make sure that the USB cable does not become squashed or

bent and does not come into contact with hot surfaces.

■ Protect the article from heat, naked ﬂ ames, extreme tempera-

tures, persistent moisture, wet conditions and collisions.

■ The article must not be used if it shows obvious signs of dam-

age.

■ The individual LEDs cannot be replaced.

Items Supplied and Article Overview

1 Barrel connec-

tor input (on the

side)

2 On / Off switch

(on the side)

3 LEDs (10 x)

4 Letters and sym-

bols (173 x)

5 Battery compart-

ment (on the

back)

6 Rails

Not shown: 1 x USB cable (A connector to barrel connector)

Inserting / Changing the Battery

For battery operation, 6 x 1.5 V batteries, AA type are re-

quired. These are not supplied with the article.

1. Open the battery compartment (5): Grip and press down the

locking lug on the battery compartment cover. Lift up the cover

at the same time.

2. Take the used batteries out if necessary and insert 6 x 1.5 V

batteries of the AA type. Pay attention to the correct polar-

ity (+ / –).

3. Reattach the battery compartment cover and press it shut.

When you do this, make sure that the locking lugs sit in the

recesses which are provided for them. You must hear and feel

it engage.

Putting Into Operation

1. Unpack – Unpack all parts and check the items supplied for

completeness (see the “Items Supplied and Article Overview”

section) and possible transport damage. If you ﬁ nd any dam-

age to the components, do not use them (!), but contact our

customer service department.

2. Attach or set up – Attach the article at a suitable height on a

wall using suitable fastening materials.

It is essential to follow the safety instructions for assembly

(see the “Important Instructions” chapter).

The article can also be set up on a ﬂ at, dry surface.

3. Insert batteries / use USB cable – Insert batteries into the

article (see the “Inserting / Changing the Battery” section).

If the article is to be operated with the USB cable, connect the

end with the barrel connector to the barrel connector input (1)

on the article and connect the other end with the USB connec-

tor to a power source, e.g. a computer, or via a suitable mains

adapter that supplies at least 1 A (not supplied with the article)

at a plug socket.

4. Select and insert – Select the letters and symbols (4) you

want and carefully insert them into the rails (6) of the article.

Make sure when you do this that the letters and symbols (4) ﬁ t

in the rails (6) at the top and bottom.

5. Switch on / off – To switch on the article, move the On / Off

switch (2) to position I.

To switch the article off again, move the On / Off switch (2) to

position 0.

Cleaning and Storage

CAUTION!

■ Under no circumstances should you use any corrosive or abra-

sive cleaning agents, rough sponges or knives to clean the

article. These could damage the surfaces.

1. Disconnect the article from the USB cable or take the batter-

ies out of the article (see the “Inserting / Changing the Battery”

section).

2. Clean the article and all accessories with a soft cloth and a lit-

tle mild detergent if necessary.

3. Thoroughly dry the article and all accessories before it is reas-

sembled and / or stored away.

4. Store the article in a dry place that is protected from sunlight

and is not accessible to children and animals.

Technical Data

Model number: 42830(I2012)A

Article number: 03037

Power supply: 9 V

(6 x 1.5 V batteries, AA type)

USB: 5 V, 0.8 A (min.)

Disposal

The packaging material is recyclable. Dispose of the pack-

aging in an environmentally friendly manner and take it to a

recycling centre.

Dispose of the article in an environmentally friendly man-

ner at a recycling centre for used electrical and electronic

devices. It should not be disposed of in the normal house-

hold waste. More information is available from your local

authorities.

The batteries should be removed prior to disposal of the

article and disposed of separately. To protect the environ-

ment, non-rechargeable and rechargeable batteries must

not be disposed of with normal household waste, but must

be taken to suitable collection points. Also note the relevant

statutory regulations governing the disposal of batteries.

Z 03037 M DS V1 0317

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Easymaxx Z03037 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Easymaxx Z03037 Manual

Product: