703750

Easymaxx F5M-A1E - Z04271 Manual

4
Zoom out
Zoom in
Previous page
1/8
Next page
EN Instructions
Customer Service / Importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
✆ +49 38851 314650 *)
Calls to German landlines are subject to charges. The cost varies depending on the service provider.
All rights reserved.
Inserting Batteries
Four 1.5 V batteries of type C are required for battery mode.
1. Take off the battery compartment
cover on the bottom of the device:
Press the fastener on the battery
compartment cover and open up the
battery compartment cover.
2. Before inserting the batteries, check
whether the contacts in the battery
compartment
(8)
and on the batter-
ies are clean, and clean them if nec-
essary.
3. Insert four 1.5 V batteries, type C into the battery compartment.
Ensure the correct
polarity (+ / –).
4. Insert the battery compartment cover and fl ip it shut until it can
be heard to engage in place.
Replace the batteries when the power of the device starts to wane.
PLEASE NOTE! Always replace all batteries together. Do not use
batteries of different types or brands, or batteries with different ca-
pacities.
Use
PLEASE NOTE
■ Do not connect the device to a computer because the high cur-
rents could damage the computer.
1. Place the device on a table or an-
other dry, even, and fi rm base.
2. Take the cover
(1)
off the device (pull
it upwards).
3. Pull the water tank
(12)
out of the
device.
4. Pull the lamella insert
(11)
out of
the device, immerse it in cold water,
shake off any excess water and then
reinsert it with the arrow markings
ahead into the device. The frame of
the lamella insert must face the air
outlet openings.
5. Unscrew the valve
(13)
from the wa-
ter tank, fi ll the water tank with cold
tap water and screw the valve fi rmly
back onto the water tank.
6. Insert the water tank into the device.
Make sure when you do this that the
valve fi ts correctly in the valve re-
ceptacle
(9)
.
7. Once batteries have been inserted in the device, it is ready for
operation. For mains power mode, plug the Micro B connector
of the USB cable into the USB socket (7) of the device and the
A connector into the socket of a USB mains adapter (not sup-
plied with the device). Connect the mains adapter to an easily
accessible socket.
8. To switch on the device, slide the switch
(3)
to position I for
cooling level 1 or position II for the higher cooling level 2. When
the device is switched on, the operating lamp
(4)
is lit.
On the back of the device warm air is sucked in, cooled by the
water in the device and emitted again at the front (as cool air).
9. To switch off the device, slide the switch to the middle posi-
tion 0. The operating lamp goes out.
10. If you are not using the device, pull the mains adapter out of the
plug socket and the USB cable out of the device.
Cleaning and Storage
• If necessary, wipe down the device with a slightly damp cloth.
• When not in use the device should be stored in a dry place
which is not accessible to children and animals.
Troubleshooting
If the device does not work properly, check whether you are able to
rectify the problem yourself. If the problem cannot be solved with
the steps that are listed, contact the customer service department.
Do not attempt to repair a defective electrical device
yourself!
If the device does not work, check the following:
• In mains power mode:
– Are the device, USB cable and mains adapter connected to
one another correctly?
– Is the mains adapter inserted in the plug socket correctly?
– Does the mains adapter correspond to the technical data of
the device?
– Is the plug socket defective? Try another socket.
– Check the fuse of the mains connection.
• In battery mode: Are no batteries inserted, or are the batteries
inserted incorrectly, or are they too weak?
• Is there water in the water tank
(12)
and is the lamella
insert
(11)
moist?
• Is the impeller
(10)
blocked?
Technical Data
Article number: 04271
Model number: F5M-A1E
Voltage: 6 V DC (4 x 1.5 V battery, type C) or
5 V DC (USB)
Power: 2.5 watts
Protection class: III
Air throughput: 6 dm
3
Air volume: < 6730 m³/h
Evaporation volume: < 50 ml/h depending on the cooling level
Water tank: 380 ml
Disposal
Dispose of the packaging material in an environmentally
friendly manner and take it to a recycling centre.
Dispose of the device in an environmentally friendly manner
at a recycling centre for used electrical and electronic devic-
es. More information is available from your local authorities.
Batteries should not be disposed of in the normal household
waste. They should be removed prior to disposal of the de-
vice and disposed of separately from the device at suitable
collection points.
Z 04271 M DS V1.1 0118
Article number: 04271
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Easymaxx F5M-A1E - Z04271 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Easymaxx F5M-A1E - Z04271 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info