702458
23
Zoom out
Zoom in
Previous page
1/24
Next page
11 03Troubleshooting
Child lock on
Overload reduced performance
Uneven load could not spin
Close outer door then press start
Close inner door then press start
Not emptying: check hose and
coin trap
Not filling: check water supply
Fault
The child lock has not been deactivated.
The recommended wash load has been
exceeded or unusual items have been
washed. The wash load is uneven.
The machine sensed that spinning would
be unsafe. Unusual items eg: trainers
may have been washed.
Outer door not closed properly, manual
release still open.
Inner door not closed properly.
Coin trap blocked.
Machine full of suds.
Drainage hose not draining.
Water supply is not connected.
Filter is blocked.
Inlet hoses are blocked or kinked.
Drainage hose is installed incorrectly.
There is a technical fault with your
washing machine.
LCD display message
Possible causes
Solutions
Dyson Helpline
UK 0870 600 2701
email service@dyson.com
ROI (01) 475 7109
email irelandservice@dyson.com
www.dyson.com
NOTE: If an engineer is booked and it is found that the fault
could have been rectified using the troubleshooting guide,
you may be charged.
NOTE: The two drums make an unusual noise when they are
counter rotating - this is nothing to worry about.
Hold down the ’Minimum iron’ button
until ‘Child lock off’ is shown on
the LCD.
In future, refer to the programme table
section 02 or cease to wash the
particular unusual item(s).
Remove some items or reload the
machine and select ‘Spin only’ option
(see section 01).
Close the outer door, ensuring nothing
is trapped. Turn manual release
clockwise (see section 03).
Close the inner door, ensuring nothing
is trapped.
Remove blockages (see section 02).
Leave suds to settle. In future, refer to
the manufacturer’s dosage instructions.
Check that the drainage hose is installed
according to the installation instructions
(see section 01 & 02).
Check that the water supply is connected
and turned on at the tap.
Clean the filters (see section 03).
Unblock or straighten the inlet hoses.
Unblock or straighten the drainage hose.
Contact the Dyson Helpline or visit the
website www.dyson.com with the
following information:
10
55
10
10
8
9
• Your machine’s serial number
see side of machine.
• Where and when you purchased your
washing machine.
• Your address.
• The fault code that appears on the
LCD display, if applicable.
A Dyson service engineer will visit you to
test your machine and repair if necessary.
8887_CRO2_OPS_COVERS.qxd 5/11/03 3:24 pm Page 5
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dyson CR02 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dyson CR02 in the language / languages: English as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info