761231

Dyson Airblade Wash and Dry WD06 Manual

2
Zoom out
Zoom in
Previous page
1/160
Next page
2
GB
ROI
IN
MT
JM
PH
SG
LOOKING AFTER YOUR HAND DRYER
WARNING
This product is not to be used in sinks where a plug is fitted. Before engaging the water
flow ensure that the plughole is clear of any obstructions and that water can drain freely.
HOW TO USE
Place your hands beneath the Dyson hand dryer and it will automatically, creating sheets of air
to scrape water from your hands.
For best dry time results:
• Keep your hands flat and parallel to the appliance surface, approximately 5 mm from the
blade, drawing your hands through the airflow from your wrists to finger tips.
• Move your hands slowly through the airflow keeping a consistent speed, approx. 2.5 seconds
per side, alternating between front and back each time.
• Keep you hands flat, close the gaps between your fingers and keep your thumbs in to ensure
that the whole of your hand is drawn through the airflow.
TROUBLESHOOTING GUIDE
WARNING: RISK OF ELECTRIC SHOCK!
Problem Action
The hand dryer fails to start. Check that the fuse/circuit breaker is working
and that the power is connected. Must be
performed by a qualified electrician.
Ensure that the cleaning cap is removed and
that the sensors are clean and unobstructed.
If a safe method of switching is available,
turn the unit on and off. If a safe method is
not available, a qualified electrician must
perform this task.
The hand dryer is turning on and
off erratically. Ensure that the sensors are clean and free
from obstructions.
Check that the sensor cable from the tap is
securely connected. Must be performed by a
qualified electrician.
The hand dryer sometimes cuts out when
in use but resumes operation after a period
of time.
Check that the air inlet is clean and free
of dust.
Remove any dust from the air inlet.
Ensure that the air inlet is free from
obstructions and has sufficient clearance
(see installation instructions).
The dry time of the hand dryer has increased. Inspect the inlet grille for dust and remove.
Inspect the filter and change if required.
Ensure that the hose is securely attached to
the base of the tap and no leaks are present.
Must be performed by a qualified electrician.
NOTE: Ensure water feed is completely flushed of debris, copper filings etc. prior to
connecting to the product. Failure to do so will damage the solenoid valve.
The instructions in this manual and the installation guide must be followed completely,
as failure to do so may result in incorrect operation, damage to property and/or
personal injury. It is recommended that an isolation valve is fitted with this product
during installation. Dyson will not be held liable for any damage to property or
personal injury, or any loss of business or revenue, if you, your staff, your installer
or service engineers have not followed the instructions given in this manual and the
installation guide.
27.11.2017 12:51 - C92757_WD04_OPMAN_INT_X588-OWNERS-MANUAL-PART 3- TEXT.indd_15_0c2s_15_0c2s
2 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dyson Airblade Wash and Dry WD06 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dyson Airblade Wash and Dry WD06 in the language / languages: All languages as an attachment in your email.

The manual is 3,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dyson Airblade Wash and Dry WD06

Dyson Airblade Wash and Dry WD06 Additional guide - English - 1 pages

Dyson Airblade Wash and Dry WD06 Additional guide - All languages - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info