612098
45
Zoom out
Zoom in
Previous page
1/46
Next page
11. Short thread trimmer (KFA)
11.1 Check EPROM-Version
It is necessary to have at least the EPROM-Version 3312 “F”. You can check the
EPROM-Version with Parameter 179.
Parameter Settings
Parameter 136 to 2
Parameter 154 to 7
Parameter 171 Position 2 (leading edge “496")
Position 2A (trailing edge “034")
Parameter 180 Number of reversion increments 114
Parameter 181 Activation delay of reversion 10
Parameter 182 Reversion “ON”
Parameter 190 Activation angle of the thread trimmer 300
Parameter 192 Activation angle of thread tension release 310
11.2 Position of the thread-pulling knife and the counter-knife
See Service Instructions Class 767.
11.3 Adjust the thread cutting stitch before thread cutting
In order to get a s hort trimming, it is necessary that the machine executes a short stitch
right before cutting (approx. 1 - 1.5 mm).
The l ength of the last stitch before thread cutting can be adjusted. Thus, the lengths of
the c ut-off needle and bobbin threads can be influenced. Both thread ends should have
almost the same length.
The l ength of the thread cutting stitch is influenced by means of screw 1.
Turningthescrew 1inclockwisedirection
means longer stitches.
Turning the screw 1 counter-clockwise
means shorter stitches.
43
GB
1
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler 767 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler 767 in the language / languages: English as an attachment in your email.

The manual is 0,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Durkopp Adler 767

Durkopp Adler 767 User Manual - German - 46 pages

Durkopp Adler 767 User Manual - French - 46 pages

Durkopp Adler 767 User Manual - Spanish - 31 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info