613278
51
Zoom out
Zoom in
Previous page
1/51
Next page
6.2.2 Setting of machine positioning
For the machine positioning the proximity switch on the hand wheel
is used together with the incremental sensor inside the motor. These
sensors permanently measure the angle between the actual position of
the upper shaft and its reference position. The reference position is s et
up according to the accompanying Instructions mnual. For the machine
good function it is necessary to set up the reference position in the
most accurate way possible.
6.2.3 Checking of set up positions
Position 1
Switch the network switch on
Tread the pedal forwards shortly and release. The machine stops
in position 1 (see 6.2.1).
Position 2
Tread the pedal forwards shortly first and then with heel fully
backwards until the machine stops. The machine stops in position
2(see6.2.1).
6.3 Reset
By means of the s o-called reset all changed values are set back to the
pre-set ones.
The process is described in the publication “Instructions manual”.
7. Machine lubrication
Before starting up the machine must be properly lubricated with oil
according to section 9.2
of the first part of these Instructions.
8. Sewing test
This test can be performed after the machine completely stops.
Thread the machine and adjust the thread tension according to
sections 7.1; 7.2; 7.3; 7.4 of the first part of the Instructions.
Test the machine function e. g. according to section 9.2 of the first part
of the Instructions.
First sew slowly, then increase the sewing speed.
20
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler 527i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler 527i in the language / languages: English as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Durkopp Adler 527i

Durkopp Adler 527i User Manual - German - 51 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info