783570
7
Zoom out
Zoom in
Previous page
1/9
Next page
12 13
Place the spring and then
the Burr onto the Shaft. The
pointed end of the Burrs
should face into Grinder
Body.
Remember to recalibrate
and adjust to your desired
setting (See First Use).
Place the Disc onto the
Shaft so that the 6 pips*
are facing away from the
Grinder Body.
Align the Ball Bearing on the
Disc with the Recess in the
Burr. Note: You may need
to rotate the shaft to aid
alignment.
CLEANING CONTINUED
4
87
Remove the Handle.
Hold the Handle in position
to prevent it turning
and rotate the tool anti-
clockwise to gently tighten
the bearing.
Warning: do not over
tighten as this will prevent
the shaft from turning.
Place the Bearing Removal/
Adjustment tool into the
two holes on the top of the
Shaft Release Nut.
Should you wish, you can
also turn the tool clockwise
to unscrew the bearing
and shaft, so that they can
be removed for repairs or
cleaning.
Carefully Place Handle onto
the Shaft, over the top of
the Bearing Adjustment
Tool.
ADJUSTING THE BEARINGS
If the Shaft starts to become loose, the bearings can be re-tightened:
1
4
2
5
3
5a 5b
Attach the Grind Control
Dial to the Shaft by pressing
it down on the Disc to
expose the thread and
rotating clockwise at the
same time.
*
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dualit Grinder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dualit Grinder in the language / languages: English as an attachment in your email.

The manual is 1.85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info