703067

Drew Cole RediKettle - CR581 Manual

4
Zoom out
Zoom in
Previous page
1/8
Next page
USER GUIDE
1. Place the kettle on a flat level surface.
2. The power cable is stored in the under side of
the kettle base, select the desired length of cable
ensuring it exits the base using the power cable
channel.
3. To fill the kettle, remove it from the base, open the
lid and fill with water. Ensuring the body and power
base remain dry and clean.
Note: DO NOT fill the kettle over the maximum level.
Make sure the lid is closed firmly before connecting
to power supply.
4. Place the kettle on the power base and connect to
power supply.
5. The cup display will inform you how much water is
present within the kettle
Note: Should you accidentally boil the kettle without
water, boil-dry protection will prevent the kettle from
boiling, the display will read E. Should you fill beyond
the max line overfill protection will prevent the kettle
from boiling, the display will read F.
1. Press the “Power” to power on the kettle base.
Set the temperature by selecting the desired
temperature (from 60
o
C/ 70
o
C/ 80
o
C/ 90
o
C/ 100
o
C).
2. The kettle will “beep” informing you it has started
to boil. It will “beep” again at the end of the
boiling cycle to inform you it has reached the
selected temperature. As the kettle cycles though
the temperatures a red light indicates current
temperature and blue light indicates selected
temperature. Once the kettle has reached the
desired temperature the boiling cycle will end.
At any time if you would like to top up the water
temperature you just need to press the power
button and select the desired temperature.
3. After boiling, lift the kettle from the power base,
press and hold the pouring lock and pour the water.
4. Note: Do not open the lid when pouring the water,
scald risk from hot water
5. Unplug the appliance while it is not in use, dry and
clean it, and then place it on the base.
CARE & MAINTENANCE
1. Always disconnect the kettle from the power outlet
before cleaning. NEVER immerse the kettle or power
base in water or allow moisture to come into contact
with these parts.
2. Exterior cleaning: wipe over the exterior of the kettle
with a soft damp cloth, and then wipe dry with a dry
cloth.
3. Note: DO NOT use chemical or abrasive cleaners to
clean inside the kettle.
4. Clearance of deposit: minerals in water may deposit
at the bottom of kettle, which will influence the
usability of the kettle. So periodical descaling is
needed. Please use detergents according to its
instruction. Or according to the following methods
with white vinegar.
5. Fill the kettle with 3 cups of white vinegar, and then
add water until it is over the deposit in the kettle and
allow it to stand overnight.
6. Empty the solution from the kettle. Fill the kettle
with clean water to the maximum level, discard after
boiling. Repeat for several times until there is no
remnants of vinegar.
7. When the kettle is in storage or not in use, do not
fold the power cord.
Note: After boiling the base will go into “stand-by”
mode and the LED display will go out. If you wish to
check current water temperature press on/o button
and the temperature will be display.
Note: 4 hours heat retention is based on the
testing of the kettle on maximum capacity (1.7L).
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Drew Cole RediKettle - CR581 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Drew Cole RediKettle - CR581 in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info