348868
5
Zoom out
Zoom in
Previous page
1/8
Next page
5
3. Cleaning
Clean the refrigerator thoroughly at intervals, as necessary.
Remove the shelves; these, the cabinet interior and the door
should be washed with a warm solution of sodium bi-
carbonate. Finally wipe over with a cloth rinsed in warm water only,
and dry with a clean cloth. Do not wash any plastic parts in water that
is more than hand warm, and do not expose them to dry heat. The
outside of the cabinet should be wiped down regularly with a clean,
damp cloth.
NEVER USE STRONG CHEMICALS OR ABRASIVE CLEANING
MATERIALS ON ANY PART OF THE CABINET.
4. Positioning the appliance
When first using this refrigerator please consider the following points:
ENSURE REFRIGERATOR IS LEVEL
THE PIPEWORK AT THE BACK GETS HOT IN USE
THE REFRIGERATOR HAS NO 'MOTOR' AND IS THEREFORE
VIRTUALLY SILENT
ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING
During the refrigeration process, the appliance gives off heat
from the condenser (under the upper part of the rear cover)
into the surrounding air. The more ventilated the condenser is,
the more effective the refrigeration will be.
The other condition for satisfactory operation is that the appliance
stands on a flat surface. This is best seen by placing a glass of
water on top of the appliance.
It is important that the appliance is not directly exposed to radiated
heat (sunlight, radiator, near an oven, etc.).
4.1. Installation instructions
The refrigerator is equipped with an electrically heated absorption
cooling unit which is virtually silent in operation. The fridge is designed
for free-standing installation, but can be built-in if the following
conditions are complied with to ensure satisfactory operation and
maximum cooling efficiency.
IMPORTANT
Please follow the installation details below carefully Guarantee
is valid for products installed as described only.
1. The refrigerator must be le
vel both directions
2. There should be 20mm clearance to the wall
3. Ventilation must be provided as shown in alternatives A, B, C
or D (fig 2-3)
4. The ventilation duct must at least measure 105mm x the
width of the refrigerator
5. Only
the entire cooling unit must project into the duct as
shown
6. Air passing thr
ough the duct must not be preheated by any
source of heat
7. Ventilation grills, if used, must have openings of at leas
t
200cm
2
each
During installation, please ensure the mains plug is accessible
at all times.
5. Using the appliance
To start the refrigerator connect the plug to the socket outlet and
switch on the socket. The cooling fins should show signs of cooling
after about 3 hours.
The refrigerator needs about 6 hours at normal ambient temperature
to reach 6 °C in the storage compartment.
5.1. Temperature regulation
The usual setting required is in middle of the setting range on the
thermostat knob (Fig. 4), but this can vary with conditions of load and
installation. If it is found necessary to alter the setting,the knob can be
turned to a higher number to produce a colder temperature, or a lower
number to produce a warmer temperature. The effect of any
adjustment can be checked by means of a thermometer after leaving
the refrigerator operating for a further period to settle down again.
Figure 4.
GB
Figure 2.
Figure 3.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dometic ea 0610 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dometic ea 0610 in the language / languages: English as an attachment in your email.

The manual is 0,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dometic ea 0610

Dometic ea 0610 User Manual - German - 8 pages

Dometic ea 0610 User Manual - Dutch - 8 pages

Dometic ea 0610 User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info