323534
34
Zoom out
Zoom in
Previous page
1/36
Next page
-
34
-
WHAT TO DO IF…
PROBLEMS
CAUSES SOLUTIONS
None of the lights are lit. The machine
does not heat up.
- Power supply problem
- Appliance not plugged in or On/Off button not pressed
- Other
- Check the plugs and mains
- Plug in the appliance and press the On/Off button.
- Go to your local dealer
The iron does not heat up.
- Thermostat dial at the off position
- Other
- Set to the desired temperature.
- Go to your local dealer
No steam is produced.
- The reservoir is empty
- The reservoir is incorrectly inserted or has not been inserted.
- The anti-scale cartridge has not been inserted
- The pilot light ANTI-CALC flashes
- Other
- Fill the reservoir
- Insert the reservoir and push it fully in
- Insert an anti-scale cartridge into the reservoir
- Change the anti-scale cartridge. Press the steam button
- Go to your local approved service dealer
Water is produced with the steam.
- The iron soleplate is not hot enough
- Over steaming
- Water condensation in the hose
- Other
- Put the dail to the settings
●●
●●●
- Wait for the steam generator light to go out.
- Press the steam button several times
- Go to your local dealer
The machine makes a noise.
- There is no water in the reservoir
- The reservoir is incor
rectly inserted or has not been inserted.
- Other
- Fill the reservoir
- Inser
t the r
eser
voir and push it fully in
- Go to your local appr
oved ser
vice dealer
The water container cannot be inserted.
- The anti-scale car
tridge is the wr
ong way round or has not been correctly
inserted
- Remove the container and check that the anti-scale car
tridge has been cor
rectly
inserted
The suction or blowing functions do not work
- The selector switch is at
- The generator unit has not been reconnected at the base after having been
detached from the table
- Set the switch to
- Reconnect the generator unit at the base
The table does not heat up
- The generator unit has not been reconnected at the base after having been
detached fr
om the table
- Reconnect the generator unit at the base
*Bei “andere Ursachen” und falls die Probleme mit den von DOMENA genannten
Lösungsvorschlägen nicht gelöst werden können, suchen Sie bitte Ihren Händler auf.
WAS TUN WENN…
PROBLEM
MÖGLICHE URSACHEN LÖSUNGSVORSCHLÄGE
Kontrolllampen leuchten nicht auf. Das Gerät wird nicht heiß.
- Stecker steckt nicht fest in der Steckdose.
- Gerät nicht angeschlossen oder Knopf “Ein/Aus” nicht betätigt.
- Andere Ursachen*
- Steckverbindung und Stromversorgung kontrollieren.
- Gerät anschließen und Knopf “Ein/Aus” betätigen.
Das Bügeleisen wird nicht heiß.
- Thermostat steht auf “mini”.
- Ander
e Ursachen*
- Gewünschte Temperatur einstellen.
Es wird kein Dampf erzeugt.
- Dampftaste wurde nicht gedrückt
- Kein Wasser im Tank.
- Wassertank nicht richtig eingesetzt.
- Keine Kalkfilter-Kartusche im Wassertank.
- Die Kontrolllampe ANTI-CALC blinkt.
- Andere Ursachen*
-
Dampftaste drücken.
- Wassertank auffüllen.
- Wassertank fest in sein Gehäuse drücken.
- Kalkfilter-Kartusche in den Wassertank einsetzen.
- Kalkfilter-Kartusche wechseln.
Es kommt Dampf und Wasser heraus.
- Bügeleisen nicht warm genug.
- Intensive Dampferzeugung.
- Kondenswasser im Verbindungsschlauch.
- Andere Ursachen*
- Stellen Sie den Thermostat auf
●●
●●●
.
- Warten, bis die Dampferzeuger-Kontrolllampe ausgeht
.
- Dampfstoßtaste mehrmals drücken (nicht ständig darauf bleiben.
Das Gerät macht ein untypisches Geräusch.
- Kondenswasser im Verbindungsschlauch
- Kein Wasser im Behälter
- Wasserbehälter nicht richtig befestigt
- Andere Ursachen*
- Dampftaste mehrmals drücken
.
- Wassertank auffüllen
.
- Wassertank fest in sein Gehäuse drücken
.
Wasserbehälter lässt sich nicht ins Gehäuse hineinstecken. - Die Kalkfilter-Kartusche wurde nicht richtig eingesetzt.
- Behälter herausziehen und Kalkfilter-Kartusche richtig einsetzen
.
Die Gebläse- oder Absaugfunktion funktioniert nicht mehr
- Der Wahlknopf ist auf
- Die Dampfstation wurde während des Montierens nicht gut angeschlossen.
- Den Wahlknopf auf einstellen.
- Schieben Sie die Dampfstation stark gegen den Bügeltisch.
Der Bügeltisch heizt nicht auf. Die Dampfstation wurde während des Montierens nicht gut angeschlossen. - Schieben Sie die Dampfstation stark gegen den Bügeltisch.
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Domena cr 3 ecofibres at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Domena cr 3 ecofibres in the language / languages: English, German, French as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info