Manual Dirt Devil M2288 - Centec 2 (page 15 of 17) (English, German, French, Italian, Turkish, Spanish)

571438

Zoom out

Zoom in

1/17

5 Maintenance

5.3 Cleaning the exhaust filter

1. Switch off the appliance, Zchapter 4.3, „Switching off“.

2. Push the release catches of the exhaust filter cover down (Fig. 13/A)

and fold down the exhaust filter cover.

3. Remove the exhaust filter (Fig. 13/B).

4. Hold the exhaust filter deeply into a dustbin.

5. Only now separate the exhaust filter element from the filter holder

(Fig. 14/A).

6. Thoroughly tap the dirt from both elements.

7. Remove residual dust with a soft brush, e.g. the supplied furniture

brush.

8. If the exhaust filter element is damaged, deformed or too soiled,

replace it (ordering information Zchapter 5.4, „Spare parts and

accessories“).

9. Put the cleaned or new exhaust filter element back into the filter holder.

10. Now put the filter holder with the freshly fitted filter back into its

receptacle (Fig. 13/B).

11. Fit the exhaust filter cover on the bottom side first (Fig. 14/B) and then

fold it in upwards.

5.4 Spare parts and accessories

 Ordering address: ZPage 77, „International Service“

 Further information: Z www.dirtdevil.de

 The following accessories and spare parts can be reordered:

5.5 Before you send in the appliance

Before contacting your authorised Royal dealer, Royal service partner or

appliance market or sending in the appliance, first follow the procedure in

the following table to check if you can solve the problem yourself.

A B

ATTENTION:

The exhaust filter element is not washable.

ATTENTION:

Only use original spare parts from the scope of delivery or those that you

have acquired by reordering.

Item number Description

2828001 Filter set 5 pcs, consisting of 1 central lamellae filter,

1 motor protection filter, 1 exhaust filter and

2 filter fleeces

M203 1 parquet brush

M209 1 turbo brush

WARNING:

Danger of injury! Never use a defective appliance! Always switch off the

appliance and disconnect it from the mains before starting troubleshoot-

ing Zchapter 4.3, „Switching off“.

Problem Possible cause / solution

The appliance

will not start.

The socket does not carry current.Test the vacuum

cleaner at another socket which you are sure carries

current.

Power cord is damaged. Have the power cord replaced

by Royal Appliance Customer Service, address,

ZPage 77, „International Service“.

The vacuum

cleaner stops

suddenly.

The overheating protection has tripped (possibly due

to blocked suction channels, filters, or similar).

Switch the appliance off and pull the plug out of the

socket. Remove the cause of overheating (e.g. by dis-

assembling telescopic tube and suction hose and re-

moving the obstacle and/or cleaning filters). Wait for

about 45 minutes. After the appliance has cooled off,

you may switch it on again.

Cleaning indica-

tor (Fig. 1/24)

lights up.

The central lamellae filter is dirty. Clean the central la-

mellae filter, Zchapter 5.2, „Cleaning central lamellae

filter and motor protection filter“.

The dust container is full.

Empty / clean the dust container, Zchapter 5.1,

„Emptying and cleaning the dust container“.

The cleaning re-

sults are unsat-

isfactory in spite

of the appliance

working correct-

ly.

The bypass vent (Fig. 1/9) is open.

Close the bypass vent .

The attached nozzle is unsuitable. Change the nozzle,

Zchapter 3.2, „Selecting the proper nozzle“.

The suction power you set is unsuitable.

Adjust the suction power control to suit the flooring,

Zchapter 4.2, „Vacuum cleaning“, step 4.

The position of the "carpet/hard floor" selector (Fig. 1/

5) is unsuitable. Set the "carpet/hard floor" selector to

the correct position for the type of floor, Zchapter 4.2,

„Vacuum cleaning“, step 5.

The dust container is full.

Empty / clean the dust container Zchapter 5.1,

„Emptying and cleaning the dust container“.

The filter is dirty.

Clean the respective filter Zchapter 5.2, „Cleaning

central lamellae filter and motor protection filter“ or

Zchapter 5.3, „Cleaning the exhaust filter“.

Nozzle, telescopic tube or suction hose are blocked.

Remove the obstacle. If necessary, use a long wooden

stick (e.g. a broomstick) to do this.

NOTE:

If you cannot solve the problem following these instructions, contact the

Royal Appliance customer service (ZPage 77, „International Service“).

Problem Possible cause / solution

Centec.book Seite 15 Montag, 15. März 2010 9:27 09

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Dirt Devil M2288 - Centec 2 in the language / languages: English, German, French, Italian, Turkish, Spanish as an attachment in your email.

The manual is 3,61 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Dirt Devil M2288 - Centec 2 Manual

Product: