10
Dehumidification.
NOTE!
The machine operates in the cooling mode but it does not lower the room
temperature. It absorbs the excessive humidity present in the air.
1. Plug the unit into a proper electrical outlet.
2. Position the exhaust tube as shown or remove
from the air-conditioner.
3.Turn the TIMER to position ON or 1 to 8
hours automatic timer setting.
4. Set the FAN SPEED control to the desired
output of airflow, high or low.
5. Set the THERMOSTAT to the maximum
cooling position.
6.When the water tank is full, the Full Water
indicator will illuminate and the compressor will
shut off automatically, the fan will stay on
circulating the air. At this time, you must empty the water tank as described in the
Drainage section.
Continuous Drainage.
In very humid conditions to avoid the unit from shutting down when the water tank is
full the unit can also be continuously drained if a convenient drainage position is
available.
Important!
The water is only gravity drained therefore the tube must lay lower and drain at a lower level
than the outlet tube at the rear of the air conditioner.
• Before operating the air conditioner, remove the water stopper, take out the rubber
plug and connect a PVC tube 12mm diameter.
