521999
4
Zoom out
Zoom in
Previous page
1/5
Next page
DIGITAL ALLTEK
WL400 Quick Start Guide
Now that the Realtek drivers are installed, you can connect the WL400 to the computer by plugging in the USB connector
in to a spare USB port. Windows should now start the “Found New Hardware” wizard and a pop-up will be displayed on
the task bar in the bottom right corner of the screen. After about 10-20 seconds, the pop-up should show a “New
Hardware Installed Successfully” message. This indicates that everything has installed correctly and your WL400 is now
ready to be used.
If your laptop has a built-in, normal wireless adaptor, then you should turn it off whenever the WL400 is plugged in.
Consult your laptop instruction manual to find out how to do this. Following this procedure whenever the WL400 is
plugged in, will ensure that you connect via the WL400 to get the best signal range possible.
To connect to a wireless network, you must run the “Realtek USB Wireless LAN Utility” which will now be one of the
programs listed in the Start>All Programs menu. The first time you run this program, you will see the window displayed in
Fig 6 which shows that you are not connected to a wireless network.
Click on the Available Network” tab and the window shown in Fig 7 will appear which lists all of the available wireless
networks that the WL400 can detect. Select the wireless network that you wish to connect to and click the “Add to Profile”
button.
You will now be prompted to enter the Network Key
(also known as Password, WEP key or Passphrase) for
the network that you have selected. Consult the
network operator to get the necessary password and
enter this in the two boxes at the bottom of the window
shown in Fig 8. Click “OK”.
Assuming that the password was correct, the WL400
should connect to the network and you will see the
window shown in Fig 9 (next page).
If you click on the “General” tab you should see the
window shown in Fig 10 (next page) which gives the
wireless connection status.
.
Figure 6
Figure 8
www.busse-yachtshop.de | info@busse-yachtshop.de
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Digital Yacht WL400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Digital Yacht WL400 in the language / languages: English as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info