739169
4
Zoom out
Zoom in
Previous page
1/7
Next page
3 4
Upright vacuum cleaner installation and removal
Step 1, insert the coarse end of the adapter into the suction port of the hand-held
vacuum cleaner and insert it tightly;
Step 2, splice the two lengths of extension tubes into one, and insert one end of the
extension tube into the circular joint of the adapter and insert it tightly;
Step 3, insert the other end of the extend tube into the circular interface of the brush
firmly. After the tube is installed, it can be used (map)
뇈샽 25.400
When disassembling, simply pull each part out and put it back into place.
Base Installation
The charging vacuum cleaner is equipped with a base. Select a suitable place to place
the base. Place it in a dry place near the socket.
Place the base and fastening device on the floor and check for any possible
damage.
Place the base in the selected position and draw the hole with a pencil.
Install the base with the appropriate screws and bolts
If the charging plug is not yet attached to the base, place it in the appropriate
storage position.
※Attention!
Before installing or removing the product or its accessories, first make sure the
charger plug is pulled out of the jack.
Product Operation Product Operation
Charging batteries
You can choose to place the vacuum cleaner on the base (Chart A) or directly recharging.
(Chart B).
If place it on the base, place the vacuum cleaner suction hole upright.
If you do not use the base, insert the charger plug into the jack on the rear of
the vacuum cleaner.
Then plug the charger into a 100-240V,50-60Hz socket.
The red control light is light, indicate that the power plug is properly connected
to the charger and is charging. Charge for approximately 4-5 hours.
※Attention!
Please use the attached charger or other charger with the same technical parameters to
prevent any harm. In order to achieve the maximum charging capacity of the battery, the
battery should be fully charged before using the battery for the first time.
The first charge time is approximately 12 hours.
After charging for 12 hours, the charger plug should be pulled out of the jack to prevent
overload.
(Figure A) (Figure B)
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dibea LW-200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dibea LW-200 in the language / languages: English as an attachment in your email.

The manual is 2,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info