739142

Dibea D500 Pro Manual

3
Zoom out
Zoom in
Previous page
1/9
Next page
2 3
PUSH
PUSH
1
2
3
L
R
Product Maintenance Product Maintenance
Dust bin and filter screen cleaning
Use and cleaning of side brush
Sensor cleaning
Installation of side brush
Disassembly of side brush
Cleaning of side brush
Notice:
After removing the dust bin, please check whether there is any foreign matter in the
suction port and clean it.
Open it from the flap "PUSH", take out the dust bin, open the door of the dust bin, and
dump the internal garbage.
Hold the small handle of the HEPA and pull out the HEPA.
Wash the dust bin and filter screen with water and pat the accumulated dust on the HEPA.
After cleaning, put the HEPA back into the dust bin in order.
Cover the door of the dust bin and put it into the host.
At the time of installing, it shall be noted that the side
brush should be consistent with the left (L) and right (R)
of the bottom shell, and the parts are marked with "L" and
"R". After one-to-one correspondence, press directly, and
it will be OK after hearing the tone of clasping.
At the time of disassembling, grasp the three brushes at
the same time and pull them up.
Check whether the side brush is damaged or has foreign
matter.
Clean the side brush with a cleaning tool or a piece of
duster cloth.
If crimping or deformation occurs, remove the side brush
and keep it in warm water for about 5s.
When the side brush is damaged and cannot be used,
please replace it in time.
Wipe the sensor with a cleaning tool or a piece of soft cloth, as the below figure show.
Cliff Sensor Collision Rod Light Filter Rear Window
Notice: If L and R are installed incorrectly, the machine will
shake when it runs.
It is recommended to clean the dust bin once a week.
It is recommended to wash the HEPA and filter screen once after using 15 - 30 days.
Before installation, please ensure that the filter screen and the HEPA are in a dry state.
Do not expose the filter screen and HEPA to the sun.
HEPA is a replaceable accessory.
3


Need help? Post your question in this forum.

Forumrules
1

Forum

dibea-d500-pro

Reset search

  • What is the MAC address of my unit? I need this to register on my wifi. Submitted on 17-5-2021 at 19:32

    Reply Report abuse

  • I can’t connect the device to the Dibea app. It refers to an ‘intelligent distributions mode’ but. there are no instructions on how to enter that mode. Submitted on 17-5-2021 at 19:30

    Reply Report abuse

  • how do you know how much suction there is when there is when there is no readout on remote. Submitted on 21-1-2021 at 18:43

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dibea D500 Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dibea D500 Pro in the language / languages: English as an attachment in your email.

The manual is 7,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info