531765

Derbi GPR 50cc 6 Speed Engine Manual

60
Zoom out
Zoom in
Previous page
1/71
Next page
CHECKING THE OIL LEVEL
AND FUEL LEVEL PILOT
LIGHTS
- Proceed according to the following
procedure:
- Turn on the ignition switch and
check that the fuel reserve level and
engine oil level pilot light verification
check comes into operation (appro-
ximately 10 seconds) on the instru-
ment panel (if this check does not
operate, check the condition of the
battery voltage, the main fuse, the
check unit, and the electrical con-
nection to these components).
- Disconnect the connector spade of
the corresponding sensor, and short
the end that plugs into the electrical
wiring circuit with a tail of electric
cable, then turn on the ignition
switch, and the pilot light for the
reserve with the bridged sensor
should remain on: if this is not the
case, there is a fault in the electrical
wiring in the circuit for this pilot light.
Fuel level sensor:
Oil level sensor:
- Take a couple of ends of cable and
connect them to the terminals of the
battery of the machine, and put a
bulb in one of them. Disconnect the
spade connector of the sensor to be
checked, and connect the ends to
the cables. Then remove the sensor
to be checked from its socket
(taking care in the case of the fuel
sensor, because it is located at the
bottom of the tank, which should be
emptied before carrying out this
15-1
COLOUR YELLOW /
OF CABLE GREEN
BLUE / FUEL RESERVE
WHITE LIT
COLOUR YELLOW /
CABLE GREEN
BLUE / OIL RESERVE
BLACK LIT
test). Hold the sensor in a vertical position, out of the
tank for about 1 minute, after which time the pilot
lamp should come on. If the pilot light does not light
up, it is faulty, and should be replaced.
- Reinstall the sensors and the electrical connections
properly, fill the fuel tank and the oil reservoir, then
turn on the ignition key. Check that the reserve tank
pilot light operating test runs (about 10 seconds).
Keep the ignition key switched on for about 1 minu-
te, and after that time the oil and fuel reserve pilot
lights should go off and stay off. If this does not
occur, it indicates that the pilot light is faulty and in
this case should be replaced.
… 60 …


Need help? Post your question in this forum.

Forumrules
1

Forum

derbi-gpr-50cc-6-speed-engine

Reset search

  • Were does the vacuum pipe from the tank conect to on the carburettor Submitted on 24-3-2022 at 09:43

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Derbi GPR 50cc 6 Speed Engine at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Derbi GPR 50cc 6 Speed Engine in the language / languages: English as an attachment in your email.

The manual is 1,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info