686460
8
Zoom out
Zoom in
Previous page
1/11
Next page
22
OPERATION USING THE REMOTE CONTROL
Aim the remote control at the receiver (A11) on the local air
conditioner. The maximum distance between the remote
control and the appliance is 5 meters (with no obstacles
between the remote and the receiver).
The remote control should be handled with extreme care,
without dropping it or exposing it to direct sunlight and
keeping it away from heat sources.
DESCRIPTION OF THE REMOTE CONTROL FIG. D
D1) "ON/STAND-BY" button
D2) Temperature increase/decrease/programmed operation
button
D3) "MODE" button
D4) Fan speed selection button
D5) REAL FEEL selection button
D6) MAX COOLING button
D7) °C/°F selection button
D8) TIMER button
INSERTING OR REPLACING BATTERIES
Remove the cover on the back of the remote
Insert two LR03 "AAA" 1.5 V batteries in the proper position
(see the indications inside the battery compartment). If the
batteries are low, replace them with the same type.
Replace the cover.
When replacing or disposing of the remote control, the
batteries must be removed and disposed of according
to current legislation as they are damaging to the envi-
ronment.Do not mix alkaline batteries, standard (zinc-
carbon) batteries or rechargeable (nickel cadmium) bat-
teries.Do not throw the batteries in the re as they could
explode or release hazardous liquids.
TURNING THE APPLIANCE ON AND OFF
Insert the plug in the socket.
Press the (D1) button on the remote control (when the
local air conditioner is turned on, the last function set be-
fore it was shut down will start).
To turn the appliance o, press the (D1) button on the
remote control then pull the plug.
NOTE: Never turn o the local air conditioner by only pulling the
plug. Press the key and wait a few minutes before pull-
ing the plug. In this manner, the appliance can perform the
operating status checks.
SELECTING THE OPERATING MODES
The commands available on the remote control correspond to
those on the appliance control panel (C).
Therefore, refer to the instructions in the previous chapters.
The D7 button, on the other hand, allows the temperature scale
to be easily changed from °C to °F and vice versa.
MAX COOLING function
This function consists in the selection of the Cooling mode with
the minimum selectable temperature and the maximum fan
speed.
This function is available only from remote control.
Once activated the Max Cooling function, next pressing of this
key will make the unit restore the previous operating mode and
settings.
D
max 5 m
D1
D4
D2
D8
D6
D5
D3
D7
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DeLonghi PAC AN98 Eco Real Feel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DeLonghi PAC AN98 Eco Real Feel in the language / languages: English as an attachment in your email.

The manual is 2,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DeLonghi PAC AN98 Eco Real Feel

DeLonghi PAC AN98 Eco Real Feel Additional guide - All languages - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info