4
• To operate the appliance at minimum without the fan, press the II button (the red area will
become visible or, in models having a switch with a warning light, the light will come on).
• Push both switches in order to get the highest power
In this model, the thermostat can be adjusted just as it is for models without a fan.
MAINTENANCE
Always pull the plug out of its electrical outlet before beginning any cleaning.
This electric convector requires no special maintenance. All you have to do is dust it off with a
soft, dry cloth — but do so only when the appliance is cold. Never use abrasive powders or
solvents.
HELPFUL ADVICE
• Do not make use of this heating convector in the immediate proximity of bathtubs, showers,
washbasins, pools, etc. In addition, this appliance must never be placed directly under a per-
manent electrical outlet.
• Do not place the power cable atop this appliance when it is hot.
• Always use this heating convector only in an upright position.
• Do not block the hot-air outlet grilles or the intake grille located on the bottom of the applian-
ce.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent in
order to avoid a hazard.
• Never use this appliance in a room whose base area is less than 4 m
2
. We likewise recom-
mend that you not place this equipment in a draft, because blasts of air may adversely affect
the equipment's operational efficiency.
WARNING: In order to avoid overheating, never under any circumstances cover the
appliances during operation.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external switching device, such as a timer, or con-
nected to a circuit that is regularly switched on and off by the utility.
ELECTRICAL CONNECTION (U.K. ONLY)
A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your
socket, the plug should be cut off from the mains lead, and on appropriate plug fitted, as below. WAR-
NING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp
socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorpo-
rating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse
cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the
event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtai-
ned from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as
marked on the base of the plug.
B) If your appliance is not fitted with a plug, please follow the instructins provided below:
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Blue Neutral
Brown Live
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The blue wire must be connected to the terminal marked with the letter N or coloured black.
The brown wire must be connected to the terminal marked with the letter L or coloured red.
If you have a 3-pins plug, do not connect any wire to the “earth” terminal.
