Models with 24 hour timer (T - fig.3)
To programme the timer;
Check the time on your watch. If for example it is 10am, turn the number disc of the timer in a clockwise
direction until the number 10 on the disc lines up with the arrow head maker.
The timer is normally supplied with all the teeth pushed into the centre allowing continuos operation. To set
the periods of time you would like the aappliance to be off continue as follows;
Each tooth corresponds to aperiod of 15 minutes ot time. Push the teeth with your thumbnail to the outerrim
of the timer. At this point, the sectors that correspond to the periods to be on and off will be visible.
The heater will now function automatically everyday, swithching on and off according to your selection.
(Important; the plug must always be inserted into the electrical socket)
To vary the programming times, simply return the teeth to their original position and set new periods of func-
tioning.
If you desire to operate the heater without programming it, push all the teeth toward the centre (i.e. in the
mode as normally supplied)
To completely turn off the heater turn off all the switches and remove the plug from the socket.
5.MAITENANCE
Before carrying out any maintenance, remove the plug from the electrical socket and wait until the heater has
cooled down.
The heater does not require special maintenance. Simply dust it off with a soft, dry cloth. Never use abrasive
powders or solvents. If necessary, remove concentrated areas of dirt with a vacuum cleaner.
6. WARNINGS
Do not use the heater in a bathroom or in the vicinity of bathtubs, washbasins, showers or swimming pools.
Never use the heater to dry laundry.
Never place the power cable on the top of the heater while it is hot.
Only use the heater in an upright position.
The heater must be positioned at least 50 cm from furniture or other abjects.
If the power cable is damaged, it must be replaced by the manifacturer or an autorized technical service
cetre.
On using the appliance for the first time, turn it on to the maximum power setting for at least 2 hours.
This is to eliminate the “new odour” which is released by the appliance. During this time ensre that the room
is well ventilated.
It is normal for the heater to make “crackling” noises during the first time it is switched on (or inthe case of
infrequent use)
The heater must not be placed immediately under a fixed electrical outlet.
The body of the heater is filled with an exact quantity of oil. If reparations may be necessary which call for
the openning of the heater, they must be done only by the manifacturer or by an autorized service centre. In
the unlikely event of oil leakage, contact the manifacturer or by an autorized service centre.
Do not use trhis appliance in room which have an area smaller than 4m
2
.
The appliance must never be placed immediately under a fixed mains socket.
When scrapping the appliance, respect legislation on the disposal of oil.
IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous
overheating.
The use of an extension lead is not recommended, as overheating of the extension lead may occur during
the operation of the heater.
5786000600/06
