34
3. Press the button to set the auto-start time. (If you hold the button down, the time is
changed rapidly).
4. Press the button to confirm the value;
5. Press once and the appliance displays the message:
AUTO-START NO
Press the button to modify the function (the appliance displays: AUTO-START Yes)
6. Press the button to activate auto-start;
NOTE: when the appliance is turned off and auto-start time is set, the symbol appears alongside the
time on the unlit display.
7. Press the button to exit programming mode or to change other parameters.
16.3 DESCALE
Over time, the continuous heating up of the water used to make the coffee leads to lime scale building up in
the inner circuits of the appliance.
When the appliance displays the message:
DESCALE
you should perform the descale cycle.
Proceed as follows:
1. make sure the appliance is ready.
2. press the button (the light over the button comes on) then press the button repeatedly until
the appliance displays:
DESCALE No
3. Press and the appliance displays the message:
DESCALE Yes
4. Press the button to start the descale programme.
5.
Empty the water tank and add the contents of one bottle (125 ml) of DURGOL descaler plus
one litre of water.
For subsequent descaling, use descaler of the same type and brand as supplied
(available from technical service centres authorised by the manufacturer).
6. attach the water spout to the nozzle;
7. place a container with a minimum capacity of 1.5 litres under the hot water spout (Fig. 3);
8. press the button. Descaler runs off from the hot water spout into the container below. The applian-
ce displays:
APPLIANCE IN DESCALE
9. the descale programme automatically performs a series of run offs and pauses to remove lime scale depo-
sits from inside the coffee maker.
10.After about 30 minutes, the appliance displays:
RINSING FILL TANK
The appliance must now be rinsed through to eliminate residues of descaling solution from inside the applian-
ce. Proceed as follows:
11.empty the water tank, rinse and fill with clean water.
12.Reposition the tank.
13.Empty the full container and then put it back under the hot water spout.
14.Press the OK button. Hot water is run off from the spout into the container below and the appliance dis-
plays:
