TROUBLESHOOTING
Check the following points before calling your local authorised Service Centre.
PROBLEMS CAUSE SOLUTION
The filter is blocked.
The temperature or humidity
in the room are too low.
The room is too big for the
dehumidifying power of the
appliance.
Too many sources of humidity
in the room (pots of boiling
water, etc.)
Humidity set too high.
Clean the filter
In certain conditions, it is nor-
mal for the appliance not to
dehumidify (in certain cases,
it is recommended to heat the
environment)
Decrease the humidity set
point
The safety device has tripped
correctly. Wait for 3 minutes to pass
The tank is missing
The tank is full
The tank is incorrectly positioned
The temperature in the room is
very low
One of the sensors on the
appliance is faulty or the humi-
dity in the room is too low or
too high to be measured cor-
rectly
Replace the tank
Empty the tank
Position the tank correctly
Increase room temperature
See if the appliance starts
working again when moved
into another room with a level
of humidity within the opera-
ting limits indicated in the
"Technical Specifications" sec-
tion. If the problem persists,
call the Service Centre
The appliance is operating in
dehumidifying mode, but the
humidity does not decrease
The appliance does not ope-
rate for 3 minutes after
start-up and is displa-
yed
“ “ is displayed
“ ” is displayed
“E2”/”E3” is displayed
EN
