See
page. 32
for the measurements for building
this model in.
Fix the “anti-condensation” protection (delivered
on the top of your machine) underneath your
work surface.
To retain stability and correct alignment
you
should fix it underneath
your work surface with
the plate.
If your dishwasher is underneath a work surface
with a hob, you must add thermal insulation to
the top of the machine. You can obtain this
thermal insulation kit from your dealer.
Built-in model
Cladding the front
If you intend to clad the front of the machine to
match your kitchen units, use the mounting
template and fittings provided.
To balance the door, adjust the tension on the
springs
(see page 32)
. This is easier to do with
the door closed.
Important
: This machine functions equipped
with a wooden panel.
Levelling : Adjusting the feet
Make sure that the machine is properly upright
and stable. The four feet may be altered, adjust
them if necessary using a wrench or a
screwdriver. Badly adjusted feet may move the
door off centre and make the machine unstable.
IMPORTANT: Do not connect the dishwasher
to the power or water supply before
completing installation.
If you are installing your dishwasher on carpet,
adjust the feet so that you leave space for air to
circulate underneath the machine.
Connection to the water supply
(Fig. 2)
Unless otherwise indicated on the original pipe,
never connect your dishwasher to a hot water
supply.
Use the water supply pipe supplied with the
machine. Do not forget to place the joint in the
tap end of the pipe. The water pressure may
vary from 1 to 10 bar. In the event of high
pressure, it is advisable to fit a pressure
regulator. Your Water Company will give you the
necessary information.
Protection against water damage
Your machine is equipped with systems that
protect you from flooding.
• The
anti-overflow
safety device. The system
automatically activates the drain pump if the
water level in the tub rises too high.
•
Anti-leakage device
. This system interrupts
the water supply if a leak is detected underneath
the machine.
If one of these mechanisms is started, contact
the after-sales service to put it back into working
order.
Evacuating waste water (Fig.3)
Connect the drain pipe
A
With a ventilated siphon. The drain pipe
should be free in the siphon and should be no
deeper than 20 cm.
B
The sink U-bend. Attention : do not forget to
remove the siphon cover.
C
Directly into the sink.
Be careful to fix the drain pipe down to avoid
flooding.
In any case, the end of the pipe must be
between 60 cm and 1 m high.
Avoid folding the pipe when installing.
Supply pipe length : 1,50 m
Connecting to the power supply
You should use an earthed plug to connect to
the power supply. In case of a direct connection,
the main switch terminal should be at least 3 mm
apart.
Replacing the electric lead
WARNING: In the interests of safety, the electrical
supply lead should ONLY be replaced by the
manufacturer’s after-sales staff or a similarly qualified
person.
Your dishwasher should be fitted so that the plug
is always accessible. Do not use an extension
lead or multiple plug for connection to the
electric socket.
*
We cannot be held liable for any damage
caused by the faulty earthing of the machine.
In all cases, the connection must comply with
the standards in force in the country concerned,
together with the supplementary regulations of
the Electricity Authority. The protection system
and the model of the machine are marked on the
plate on the inside of the door on the left. The
machine must be switched off when the
connection is made to the electrical circuit.
26
GB
Installation
