608111
25
Zoom out
Zoom in
Previous page
1/28
Next page
25
CONDITIONS DE GARANTIE / GUARANTEE CONDITIONS / GARANTIEVOORWAARDEN
intempéries, locaux surchauffés ou mal ventilés.
-Alimentation avec une eau présentant des critères
d’agressivités particulièrement anormaux (DTU -
Plomberie 60-1 additif 4).
-Alimentation électrique présentant des surtensions
importantes.
L’application de la garantie est, en outre, subordonnée
à la pression de l’eau d’alimentation qui ne doit
pas être supérieure à 5 bar (0.5 MPa) à l’entrée de
l’appareil.
Une installation non conforme à la réglementation,
aux normes et aux règles de l’art - Notamment :
-Absence ou montage incorrect d’un groupe de
sécurité neuf et conforme à la norme NF EN 1487,
modification du réglage du groupe de sécurité.
-Corrosion anormale dûe à un raccordement
hydraulique incorrect ou à une absence de manchons
diélectriques (contact direct fer cuivre).
-Raccordement électrique défectueux : non conforme
à la norme d’installation NFC 15-100, mise à la terre
incorrecte, section de câble insuffisante, non respect
des schémas de raccordement prescrits etc…
-Mise sous tension de l’appareil sans remplissage
préalable (chauffe à sec).
- Position de l’appareil non conforme aux consignes
de la notice.
Un entretien défectueux:
-Entartrage anormal des éléments chauffants et des
organes de sécurité.
-Non entretien ou dysfonctionnement du groupe
de sécurité se traduisant par des surpressions (voir
notice).
- Corrosion de cuve avec dissolution complète de
l’anode de magnésium.
-Carrosserie soumise à des agressions extérieures.
-Modification des équipements d’origine, sans avis
du constructeur ou emploi de pièces détachées non
référencées par celui-ci.
3) - Recommandations
2) - Guarantee limits.
These guarantees exclude failures due to:
Abnormal environment conditions:
- Placement in a location subject to frost or bad weather.
Very warm or badly ventilated rooms.
- Supply using water with abnormal aggressive criteria
(DTU - Plumbing 60-1 addendum 4).
- Electricity power supply with severe overvoltages.
Furthermore, the guarantee will be null and void if the
water supply pressure at the water heater inlet exceeds
5 bar (0.5 MPa).
An installation not in conformity with the regulations,
standards and standard practice, and particularly:
- Omission or incorrect installation of a new safety valve
according to standard NF EN 1487, modification of the
setting of the safety valve.
- Abnormal corrosion due to an incorrect water
connection or if the dielectric connections are not fitted
(direct contact between iron and copper).
- Defective electrical connection (not conform with
installation standard NF C15-100, incorrect earthing,
cable with inadequate cross-section, failure to respect
specified connection diagrams etc…
- Equipment switched on without prior filling (dry
heating).
- Equipment position not in conformity with the
instructions in the manual
- Improper maintenance:
- Abnormal scaling of heating elements and safety
devices.
- Lack of maintenance or malfunction of the safety valve
resulting in overpressures (see instructions).
- Tank corrosion with the magnesium anode being
completely corroded.
- Signs of external aggression on the casing,
- Modification of the original equipment without the
manufacturer’s permission or the use of spare parts not
referenced by the manufacturer.
3) - Recommendations
niet aangesloten op de riolering, afwezigheid van een
vergaarbak, enz...) of aan een slechte toegang te wijten
zijn.
2) - Beperkingen van de garantie
Worden niet door deze garantie gedekt, alle gebreken
die te wijten zijn aan:
Een abnormale context:
- Installatie op een plaats die aan vorst of slechte
weersomstandigheden is blootgesteld, in een
oververhit of slecht geventileerd lokaal.
- Gebruik van water met abnormaal corrosieve
eigenschappen (DTU - Loodgieterij 60-1 bijvoegsel 4).
- Aansluiting op een elektriciteitsnet met belangrijke
overspanningen.
De toepassing van de garantie is bovendien
onderworpen aan de druk van het leidingwater die
aan de ingang van het toestel niet meer dan 5 bar (0.5
MPa) mag bedragen.
Een installatie die niet aan de geldende reglementen
en normen of aan de regels der kunst voldoen, o.a.:
- Bij afwezigheid of onjuiste montage van een
nieuw veiligheidselement, en volgens de norm NF
EN 1487, bij wijziging van de afstelling van het
veiligheidselement.
- Bij abnormale corrosie n.a.v. een onjuiste koppeling
van de waterleidingen of de afwezigheid van
diëlektrische moffen (rechtstreeks contact tussen ijzer
en koper).
- Bij een gebrekkige elektrische aansluiting: niet
naleving van de installatienormen NFC 15-100,
onjuiste aarding, gebruik van kabels met een te kleine
doorsnede, het niet naleven van de voorgeschreven
schakelschema’s enz…
- Wanneer toestel wordt ingeschakeld terwijl de tank
leeg is.
- Wanneer het toestel niet volgens de richtlijnen in
deze handleiding wordt opgesteld.
Een gebrekkig onderhoud:
- Abnormale kalkaanslag op de verwarmings- en
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich CES at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich CES in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 1,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info