608111
4
Zoom out
Zoom in
Previous page
1/28
Next page
4
AVERTISSEMENTS / WARNING / WAARSCHUWING
permettre l’échange éventuel de l’élément
chauffant, laisser au-dessous des extrémités
des tubes du chauffe-eau un espace libre de
300 mm jusqu’à 100L et 480 mm pour les
capacités supérieures.
RACCORDEMENT HYDRAULIQUE
Installer obligatoirement à l’abri du gel un
organe de sécurité (ou tout autre dispositif
limiteur de pression), neuf, de dimension 1/2’’
(petite capacité) ; 3/4’’ (50 à 300l) ; 1’’ (500l),
de pression 7 bar (0.7MPa) sur l’entrée du
chauffe-eau, qui respectera les normes locales
en vigueur.
Le dispositif de vidange du limiteur de
pression doit être mis en fonctionnement
régulièrement afin de retirer les dépôts de
tartre et de vérifier qu’il ne soit pas bloqué.
Un réducteur de pression (non fourni) est
nécessaire lorsque la pression d’alimentation
est supérieure à 5 bar (0.5 MPa) qui sera placé
sur l’alimentation principale.
Raccorder l’organe de sécurité à un tuyau
de vidange, maintenu à l’air libre, dans un
WATER CONNECTIONS
A new safety device which conforms to current
standards (in Europe EN 1487), pressure 7
bar–0.7 MPa and size 1/2’’ (small tanks) ;
3/4’’ (50 to 300l) ; 1’’ (500l) in diameter must
be fitted. The safety valve must be protected
from frost.
Operates once a month the discharge of
water security to prevent scaling and verify
that it is not blocked.
A pressure reducer (not supplied) is required
when the water supply pressure exceeds 5 bar
(0,5 MPa).
Connect the safety device to an unpressurised
outlet pipe in a frost free environment, with
a continuous slope for the evacuation of the
water during heating up or draining the water
heater.
The circuit working pressure must not exceed
3 bar-0,3 MPa, its temperature must not
exceed 100°C.
DRAIN : Turn off the power and the supply
of cold water, open the hot water faucets and
manipulate the safety valve before performing
BEVESTIGING VAN EEN VERTICALE
WANDBOILER : Om de eventuele vervanging
van het verwarmingselement mogelijk te
maken, onder de uiteinden van de buizen van
het toestel een ruimte vrijlaten van 300mm tot
100L en 480mm voor de grotere capaciteiten.
HYDRAULISCHE AANSLUITING
Verplicht een nieuw veiligheidselement
installeren op de warmwatertoevoer die de
geldende normen respecteert (in Europa EN
1487), drukbereik 7 bar – 0.7 MPa en een
diameter van 1/2’’ (kleine modellen) ; 3/4’’
(50 tot 300l) ; 1’’ (500l). De veiligheidsgroep
moet tegen vorst beschermd worden.
Eenmaal per maand moet de afvoerhendel
van de veiligheid geactiveerd worden om
verkalking te voorkomen en te controleren dat
het niet geblokkeerd is.
Er is een reduceerventiel meegeleverd) nodig
als de toevoerdruk hoger is dan 5 bar - 0,5
MPa.
Sluit de veiligheid van het apparaat hellend
aan op een afvoerpijp, toegankelijk en in een
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for De Dietrich CES at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of De Dietrich CES in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 1,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info