529060
12
Zoom out
Zoom in
Previous page
1/12
Next page
Days Verb Power Chair
User Manual
- 12 -
Footrests
Adjustment Procedures
Swing-away Footrest
Length
Adjustment
Adjustments are made with the user sitting in
the wheelchair with feet on footplates.
1) Use a spanner to loosen the bolt at the rear of the footrest support hanger.
2) Adjust the footplate up or down as needed to provide maximum support of
thighs on the seat upholstery, then re-tighten the bolt.
WARNING!
Ensure that desired front rigging adjustment does not cause pressure to legs
at front of seat upholstery.
Folding Back
This is available to reduce the overall height of the chair. Whilst at the rear of the
chair, grip the small lever and push down to release pin allowing the handle sec-
tion to be folded.
Negotiating Inclines
The Powerchair has climbing power that enables you to overcome gradients
of up to 12° (1:5).
Always approach an incline directly, not at an angle, and follow it
up or down directly avoiding zigzag movement.
CAUTION! - Never attempt to climb or descend an incline
which has a slippery or icy surface.
While going uphill or downhill there is no need for drastic cor-
rective joystick movements. The electronic controller ensures
that the extra power required for climbing is automatically ap-
plied to the motors, so that the selected speed is maintained. This
is achieved by the micro-computer of the electronic controller
compensating automatically for any extra power required.
The same applies when you travel downhill. The electromagnetic safety brake
gives you full control over your Powerchair at all times. This unique brake sys-
tem enables you to descend at a constant slow speed.
BE CAREFUL
- 13 -
You can stop at any time while you are climbing or descending. Simply release the
joy-stick as on the flat. The electromagnetic safety brake will ensure that the
Powerchair is positively locked and secured in parking position until you are ready
to continue your journey.
Anti Tippers
These are fitted at the rear of the chair, adjacent to the rear drive wheels and must
be fitted at all times when driving outdoors. Especially when climbing kerbs and
gradients.
Kerb Climber (Std)
This is attached at the front of the chair from one side frame to the other. The centre
climbing shoe is set at 10 mm clearance and is designed to lift the front of the chair
over a kerb higher than this as you drive forward, returning to its original position
due to its spring action.
Approach the kerb head-on slowly. Shortly before the front wheels make contact
with the kerb push the joystick fully forward for maximum power.
Do not allow the power chair to come to a halt midway through manoeuvre. If pos-
sible, use gentle upper body movement to assist motion.
CAUTION! - Ensure all wheels have mounted the kerb before changing direction.
When climbing kerbs you will find that your Powerchair will smoothly overcome
the kerb without the need for drastic speed variations.
Transferring to and from the chair (Ensure chair is switched off)
Circumstances and individual needs will vary from person to person, but if there
are difficulties we advise you to consult your therapeutic adviser who will help to
develop your skill for appropriate transfer method that suit your individual require-
ments.
During transfer always make sure that the brakes are in a locked position and the
Powerchair is manoeuvred as close as possible to the transfer seat .
Circuit Breaker
If your chair stops for no apparent reason, it is probably due to the circuit breaker.
The circuit breaker can be located on the top of each battery box.. On rare occa-
sions, it happens that there is a temporary overload on the electric circuit. If this
occurs, the circuit breaker button will pop out. To reset, turn the key to the OFF
position, press circuit breaker button and then turn the key to the ON position.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Days Verb at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Days Verb in the language / languages: English as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info