3 Network Configuration
The IP address of all the cameras is the same when leaving factory (default IP 192.168.1.108).
To make the camera access to the network smoothly, please plan the available IP segment
reasonably according to the actual network environment.
3.1 Modify IP Address
The cameras which are accessed via wired network can acquire and modify the IP address
through “Quick Configuration Tool”. For the wireless network cameras, you need to connect to
the wired network to configure wireless parameters before use.
This section introduces the approach of modifying IP address via “Quick Configuration Tool”. You
can also modify the IP address in the network parameters of the WEB interface. Please refer to
the document WEB Operation Manual in the disk for more details.
Note
Only when the IP addresses of the camera and the computer are in the same network segment,
the camera can be configured.
To modify IP address, do the following:
1. Double-click “ConfigTools.exe” to open the “Quick Configuration Tool”.
2. Double-click the device that needs to be configured.
The system will pop out the Login dialog box. See Figure 3-1 for more details.
3. Enter the IP address, username, password and port number of the camera, and then click
OK.
Note
The default username and password is admin and admin respectively, and the default port is
37777.
Figure 3-1 Login
4. Modify the camera IP address on the Net interface, and then click Save to finish modification.
