498242
20
Zoom out
Zoom in
Previous page
1/24
Next page
20
Caution
Please avoid to connect speaker (-) to the ground or vehicle chassis.
2-Channel-Mode: 2 Subwoofers / Mono bridged
Cable connection
• Connect the INPUT of the amplifier to the head unit line output with a good quality RCA cable.
By connecting the RCA jacks OUTPUT with a additional amplifier, a full range signal will be
provided to the amplifier.
• Connect the subwoofers with the terminal block (CH1/2 + BRIDGED - SPEAKER OUTPUT
and CH3/4 + BRIDGED - SPEAKER OUTPUT ) of the amplifier.
• The minimum final subwoofer impedance must not be below 4 Ohm per channel. Too low
speaker loads result in too high heat dissipation and may cause the amplifier run into
protection.
• Please observe speaker channel and polarity as printed by the speaker terminal block.
Incorrect phasing of the speakers results in total loss of bass response.
TWIN SUB - Switch CH1/2
• The TWIN SUB - Switch must be set this configuration to "ON"-Position.
• The controllers for HIGH PASS, LOW PASS and BASS BOOST for CH1/2 are in this configuration not in use.
The parameters for HIGH PASS, LOW PASS and BASS BOOST for CH1/2 will be taken from CH3/4.
INPUT MODE - Switch
• The INPUT MODE - Switch must be set in this conguration to "2CH"-Position.
X-OVER - Switch & Control CH3/4
• See page 17.
LEVEL INPUT - Control
• See page 17.
BASS BOOST - CONTROL CH3/4
• The BASS BOOST - Control increases the bass level at 45 Hz from 0 up to 12dB. Please use the Bass-Boost carefully.
BASS REMOTE
• The BASS REMOTE allows to control the Bass-Level of Subwoofer 1 on CH1/2 and Subwoofer 2
on CH3/4 simultaniously for example from the driver's seat.
CH3CH3
LINE INPUT LINE INPUT
OUTPUT OUTPUT
LL
RR
LINELINE
BASS REMOTEBASS REMOTE
CH1CH1
CH4CH4
CH2CH2
PROTECTPROTECT PWRPWR
BPFBPF
4V4V
30Hz3 0Hz
150Hz150Hz
0dB0dB 12dB12dB
BASS B OOSTBASS B OOST
0.2V0.2V
1.2kHz1.2kHz
10Hz10Hz
HIGH P ASSHIGH P ASSLOW P ASSLOW P ASS
LEVEL I NPUTLEVEL I NPUT
BPFBPF
4V4V
30Hz30Hz
150Hz150Hz
0dB0dB 12dB12dB
0.2V0.2V
1.2kHz1.2kHz
10Hz10Hz
4CH4CH 2CH2CH
INPUTINPUT MODEMODE
OFFOFF ONON
TWIN TWIN SUBSUB
BASS B OOSTBASS B OOST
HIGH P ASSHIGH P ASSLOW P ASSLOW P ASS
LEVEL I NPUTLEVEL I NPUT
CH3 / CH4CH3 / CH4
CH1 / CH2CH1 / CH2
X- O VERX- O VER
LP/BPLP/BP HPHP FULLFULL
X- O VERX- O VER
LP/BPLP/BP HPHP
FULLFULL
S EAKERP
OUTP TU
FUSE
BRI EDDG
L R
GND
REM 12V
WEPO R
PI
N UT
BR DGEI D
L
R
Subwoofer 2
4 - 8 Ohm
Subwoofer 1
4 - 8 Ohm
BASS REMOTE
Connect RCA outputs
from head-unit with
RCA inputs (LINE
INPUT CH1/2).
4 Channel Amplifier - Speaker- & RCA-Connection
GTR440.4 – GTR640.4
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Crunch GTR620.2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Crunch GTR620.2 in the language / languages: English, German as an attachment in your email.

The manual is 3,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info